- ページ 16

サーバー Cisco SNS-3595-K9のPDF ソフトウェアのインストールをオンラインで閲覧またはダウンロードできます。Cisco SNS-3595-K9 38 ページ。
Cisco SNS-3595-K9 にも：インストレーション・マニュアル (36 ページ)

Install the Side Rails

Figure 6: Front Securing Mechanism, Inside of Front End

Front mounting pegs

Rack post

Step 3

Install the outer slide rails into the rack:

a) Align one slide-rail assembly front end with the front rack-post holes that you want to use. The slide rail front-end

wraps around the outside of the rack post and the mounting pegs enter the rack-post holes from the outside-front (see

the figure above).

The rack post must be between the mounting pegs and the open securing plate.

Note

b) Push the mounting pegs into the rack-post holes from the outside-front.

c) Press the securing plate release button, marked PUSH. The spring-loaded securing plate closes to lock the pegs in

place.

d) Adjust the slide-rail length, and then push the rear mounting pegs into the corresponding rear rack-post holes. The

slide rail must be level front-to-rear.

The rear mounting pegs enter the rear rack-post holes from the inside of the rack post.

e) Attach the second slide-rail assembly to the opposite side of the rack. Ensure that the two slide-rail assemblies are at

the same height with each other and are level front-to-back.

f) Pull the inner slide rails on each assembly out toward the rack front until they hit the internal stops and lock in place.

Step 4

Insert the server into the slide rails:

This server can weigh up to 67 pounds (59 kilograms) when fully loaded with components. We recommend

Caution

that you use a minimum of two people or a mechanical lift when lifting the server. Attempting this procedure

alone could result in personal injury or equipment damage.

Figure 7: Inner Rail Release Clip

Install Cisco ISE Software on Cisco SNS Appliances

Securing plate shown pulled back to open position