ページを印刷する
strapped Speaker Wiring Diagram
SLD5k
Linking or strapping makes 2 ampli ers work as a single ampli er.
This con guration will near double the rated output power.
Follow the instructions carefully as it can cause harm to your system if done incorrect.
Speaker impedance 2 Ohm ~ 16 Ohm
Loads under what is speci ed will cause excessive heat & the ampli er
will reach thermal at a faster rate & will eventually go into protect.
Strapped impedance load under 2 ohm is not warranted!
To link the master and slave ampli er speaker connection follow the steps below.
step 1.
Run the
positive (+)
positive terminal (+)
step 2.
Run the
positive (+)
negative terminal (-)
Step 3.
Connect both ampli ers together by running a cable from negative speaker output on master ampli er
to negative speaker output on slave ampli er. Use minimum 8 GA cable for connecting the ampli ers.
master
BASS
REMOTE
FREQ.
GAIN
SUBSONIC
BOOST
6V
0.2V
10Hz
50Hz
0dB
9dB
30Hz
90Hz 35Hz
L
R
INPUT
Speaker Impedance 2~ 16 ohm
slave
BASS
REMOTE
GAIN
SUBSONIC
BOOST
FREQ.
0.2V
10Hz
50Hz
0dB
9dB
30Hz
6V
L
R
INPUT
speaker cable from the
master
of the subwoofer.
speaker cable from the
slave
of the subwoofer.
LPF
PHASE
POWER
MASTER
PROTECT
SLAVE
250Hz
0
180
OUTPUT
INPUT
MASTER
SLAVE
LPF
PHASE
POWER
MASTER
PROTECT
90Hz 35Hz
250Hz
0
180
SLAVE
OUTPUT
INPUT
MASTER
SLAVE
ampli er's speaker output to the
ampli er's speaker output to the
9
SPEAKER
*
Leave Master unpressed
SPEAKER
*Press the switch on the slave for
strapped mode