- ページ 5

サーバー Cisco UCS B200 M3のPDF アップグレードマニュアルをオンラインで閲覧またはダウンロードできます。Cisco UCS B200 M3 21 ページ。 Blade server
Cisco UCS B200 M3 にも：インストレーション・マニュアル (34 ページ), インストールとサービスノート (36 ページ), インストールとサービスノート (37 ページ), マニュアル (8 ページ), インストールとサービスノート (28 ページ)

ページを印刷する

Do not continue with the next step until the board controller activation completes. Verify whether the

Step 10

activation is complete by using the show version command.

As shown in the example below, wait until the Activate-Status returns Ready. This process takes a few

minutes before the Activate-status is successfully completed and returns Ready.

# show version

BoardController:

Step 11

Clear the WILL_BOOT_FAULT

Upgrade Scenario 2: UCSM and BIOS at Version 2.1(3a) or Later, CPU Earlier Than Intel E5-2600 v2

This scenario assumes the following conditions:

•

In this case, the server already has the software and firmware prerequisites. Use the following procedure

to upgrade the CPUs:

Disassociate the server in Cisco UCS Manager.

Step 1

Power off the server.

Step 2

Step 3

Replace the CPUs with the Intel E5-2600 v2 Series CPUs.

Use the procedures in the

Step 4

Reinsert the server to the chassis.

Wait for Cisco UCS Manager to automatically discover the server.

Step 5

Note

Step 6

Perform a board controller activation by using the Cisco UCS Manager CLI interface. Use the following

sequence of commands:

OL-28629-02

Running-Vers: 8.0

Package-Vers:

Activate-Status: Ready

In the Navigation pane, click the Equipment tab.

On the Equipment tab, expand Equipment > Chassis > Chassis number > Servers, then choose

your server.

In the Work pane, click the General tab.

In the Actions area, click Recover Server.

In the Recover Server dialog, click Reset CIMC (Server Controller), then click OK.

Wait for CIMC to reboot and for Cisco UCS Manager to do a shallow discovery of the server. This

takes two to three minutes. At the end of this process the WILL_BOOT_FAULT is cleared.

The Cisco UCS Manager software is at version 2.1(3a) or later.

The server is already using BIOS/CIMC version 2.1(3a) or later.

The server is using CPUs earlier than Intel E5-2600 v2 Series CPUs.

Blade Server Installation and Service Note

At this point, the Health LED of the server shows a critical fault and Cisco UCS Manager reports

a generic error message:

controller activation is required, as described in the next step.

Cisco UCS B-Series Servers Upgrade Guide for Intel E5-2600/E5 2400 v2 Series CPUs

using the Cisco UCS Manager GUI to reset the server CIMC:

WILL_BOOT_FAULT: Sensor failure asserted

Cisco UCS Blade Server

for your server.

. This is because a board