- ページ 41

サーバー Cisco UCS B260 M4のPDF インストールとサービスノートをオンラインで閲覧またはダウンロードできます。Cisco UCS B260 M4 46 ページ。 Blade server
Cisco UCS B260 M4 にも：インストールとサービスノート (50 ページ)

This chapter contains the following sections:

•

Upgrading to a Cisco UCS B460 M4 Blade Server

Before You Begin

• Ensure that the UCS B260 M4 Blade Module is installed in slot 7 in the chassis. This module will the

• Ensure that the UCS B260 M4 Blade Module from the upgrade kit is installed in slot 5 in the chassis.

The KVM cable, USB flash device, and the SD cards must be configured in the UCS B260 M4 Blade

Note

Module installed in slot 7. These components only operate in the master blade.

The following procedure describes installing a UCS B460 M4 blade server in slots 7 and 5. Other slot

combinations can also be used, including slots 5 and 3, and slots 3 and 1. However, the heaviest blade server

in the chassis should be installed in the lowest slots so if only one UCS B460 M4 is to be installed, then it

should go in slots 7 and 5.

Procedure

Step 1

Remove the UCS Scalability Terminator from the UCS B260 M4 Blade Module installed in slot 7. See

Removing the Scalability Terminator, on page

Step 2

Install the UCS B260 M4 Blade Module from the upgrade kit into slot 5 if the module is not already installed.

Step 3

Use the UCS Scalability Connector to connect together the blade modules in slot 7 and slot 5. See

a Scalability Connector, on page

Upgrading to a Cisco UCS B460 M4 Blade Server, page 33

Removing the Scalability Terminator, page 34

Installing a Scalability Connector, page 34

be master in the UCS B460 M4 blade server.

Cisco UCS B260 M4 and B460 M4 Blade Server Installation and Service Note for Servers with E7 v4 CPUs

C H A P T E R

34.

Installing