- ページ 11

サーバー Cisco UCS C SeriesのPDF 設置マニュアルをオンラインで閲覧またはダウンロードできます。Cisco UCS C Series 19 ページ。 Security manager 4.3
Cisco UCS C Series にも：トラブルシューティングのヒント (11 ページ), アップグレードマニュアル (11 ページ), アップグレードマニュアル (10 ページ), クイック・スタート・マニュアル (12 ページ), セットアップ (10 ページ)

Installing the Server

Server Default Settings

The server is shipped with these default settings:

• The NIC mode is Shared LOM EXT.

• The NIC redundancy is Active-Active. All Ethernet ports are utilized simultaneously.

• DHCP is enabled.

• IPv4 is enabled.

Connection Methods

There are two methods for connecting to the system for initial setup:

• Local setup—Use this procedure if you want to connect a keyboard and monitor directly to the system

• Remote setup—Use this procedure if you want to perform setup through your dedicated management

Connecting to the Server Locally For Setup

This procedure requires the following equipment:

• VGA monitor

• USB keyboard

• Either the supported Cisco KVM cable (Cisco PID N20-BKVM); or a USB cable and VGA DB-15 cable

Step 1

Attach a power cord to each power supply in your server, and then attach each power cord to a grounded AC power outlet.

Wait for approximately two minutes to let the server boot to standby power during the first bootup. You can verify system

power status by looking at the system Power Status LED on the front panel. The system is in standby power mode when

the LED is amber.

Step 2

Connect a USB keyboard and VGA monitor to the server using one of the following methods:

Shared LOM EXT mode enables the 1-Gb/10-Gb Ethernet ports and the ports on any installed Cisco

virtual interface card (VIC) to access the Cisco Integrated Management Interface (Cisco IMC). If you

want to use the 10/100/1000 dedicated management port to access Cisco IMC, you can connect to the

server and change the NIC mode as described in

Utility, on page

13.

for setup. This procedure can use a KVM cable (Cisco PID N20-BKVM) or the ports on the rear of the

server.

LAN.

Note

To configure the system remotely, you must have a DHCP server on the same

network as the system. Your DHCP server must be preconfigured with the range

of MAC addresses for this server node. This server node has a range of six MAC

addresses assigned to the Cisco IMC. The MAC address printed on the label is

the beginning of the range of six contiguous MAC addresses.

Connecting to the Server Locally For Setup

Setting Up the System With the Cisco IMC Configuration

Installing the Server