- ページ 4

ゲートウェイ Cisco 2621のPDF オペレーションをオンラインで閲覧またはダウンロードできます。Cisco 2621 25 ページ。 Gateway-pbx interoperability: lucent/avaya definity g3si with e1 pri net5 signaling
Cisco 2621 にも：ユーザーマニュアル (35 ページ), ユーザーマニュアル (20 ページ)

ページを印刷する

The 2621XM/2651XM Router

Figure 2

Cisco 2650

10/100BASE-T

Ethernet 0/1

Network

module

The Cisco 2621XM and 2651XM routers feature a console port, an auxiliary port, dual fixed LAN

interfaces, a Network Module slot, and two WIC slots.

LAN support includes single and dual Ethernet options; 10/100 Mbps auto-sensing Ethernet; mixed

Token-Ring and Ethernet; and single Token Ring chassis versions.

WAN interface cards support a variety of serial, ISDN BRI, and integrated CSU/DSU options for

primary and backup WAN connectivity. Available Network Modules support multi-service

voice/data/fax integration, departmental dial concentration, and high-density serial options

All Cisco 2600 series routers include an auxiliary port supporting 115Kbps Dial-On-Demand Routing,

ideal for back-up WAN connectivity.

When a Network Module is inserted, it fits into an adapter called the Network Module expansion bus.

The expansion bus interacts with the PCI bridge in the same way that the fixed LAN ports do; therefore,

no critical security parameters pass through the Network Module (just as they don't pass through the

LAN ports). Network modules do not perform any cryptographic functions.

WICs are similar to Network Modules in that they greatly increase the router's flexibility. A WIC is

inserted into one of two slots, which are located above the fixed LAN ports. WICs interface directly with

the processor. They do not interface with the cryptographic card; therefore no security parameters will

pass through them. WICs cannot perform cryptographic functions; they only serve as a data input and

data output physical interface.

The physical interfaces include a power plug for the power supply and a power switch. The router has

two Fast Ethernet (10/100 RJ-45) connectors for data transfers in and out. The module also has two other

RJ-45 connectors on the back panel for a console terminal for local system access and an auxiliary port

for remote system access or dial backup using a modem. The 10/100Base-T LAN ports have

Link/Activity, 10/100Mbps, and half/full duplex LEDs.

panel with descriptions detailed in

Cisco 2621XM and Cisco 2651XM Modular Access Routers with AIM-VPN/EP FIPS 140-2 Non-Proprietary Security Policy

Cisco 2621XM and Cisco 2651XM Physical Interfaces

WIC slots

LINK

ETHERNET 1 ACT

LINK

ETHERNET 0 ACT

(RJ-45)

10/100BASE-T

Ethernet 0/0

Console

(RJ-45)

port (RJ-45)

Cisco 2650

100-240V– 1A

50/60 Hz 47 W

CONSOLE

AUX

Auxiliary port

(RJ-45)

Figure 3

Table

shows the LEDs located on the rear

OL-6262-01