- ページ 4

ゲートウェイ Cisco ACE XML GatewayのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco ACE XML Gateway 8 ページ。 Cisco ace xml gateway quick start guide

This document provides an overview of the setup procedure. For complete information, see

Note

the Cisco ACE XML Gateway Installation and Administration Guide.

The initial configuration of the appliance is accomplished from its shell environment. The ACE XML

Gateway provides a menu-based shell interface that eases the task of setting the initial configuration

for the appliance.

To access the system shell, follow these steps:

With the appliance turned off, connect an input device using one of these methods:

Step 1

• By direct console connection. Use the video connectors on the front and back panels of

the appliance to connect a monitor to the appliance. The back panel contains keyboard

and mouse connectors, and the front panel has USB ports that can accept a USB mouse

and keyboard. Use any of these connectors to connect a monitor and keyboard or KVM

device to the appliance.

• By serial connection. To access the system shell by serial connection, connect a

workstation (laptop or desktop computer) by serial cable to the serial connector on the

back panel.

If using a serial connection to the appliance, in the communications software on the attached

Step 2

workstation, configure a connection with these settings:

• Bits per second: 9600

• Data bits: 8

• Parity: None

• Stop bits: 1

• Flow Control: None

The emulation mode for the connection should be VT100.

Power up the appliance. The power button appears on the right side of the front panel. After

Step 3

the appliance boots up, a login prompt appears.

Step 4

specifically provided to you. If using a serial connection, establish the connection with the

communication software.

If you used the default username and password to log in, you are prompted to enter a new password.

Follow the instructions on the screen to change your default password.