- ページ 2

遊び場機器 b4Adventure Playzone-Fit Balance BloxのPDF マニュアルをオンラインで閲覧またはダウンロードできます。b4Adventure Playzone-Fit Balance Blox 4 ページ。

CHOOSING THE BALANCE OR QUAD BLOX SET UP LOCATION

• Select an open area, free of any furniture or other hard objects. The floor should be level and smooth. If

you can place some gym mats (not included, but can be purchased at any sporting goods or dance

supply store) or other soft mats or carpets, that will help prevent injury from any accidental falls from the

line. You can also use short grass areas outside. NOTE: USER ASSUMES ALL RISKS ASSOCIATED

THE USE OF THIS PRODUCT.

ASSEMBLY INSTRUCTIONS

• FOLLOW THE ASSEMBLY INSTRUCTIONS CAREFULLY. Check parts for any wear or damage.

Replace worn or damaged parts- USE ONLY B4Adventure PARTS!

• Assemble the pole by inserting the two male ended poles into the single, female section (Figure 1)

• Insert the pole with the hole side up into the Balance Blox™ (Figure 2)

• Drop a bolt into the hole on the bottom of the block (Figure 3) and place a nut on the inside of the block.

• Hold the nut on the inside of the block (Figure 4)

• Tighten the bolt from the bottom using the tool until it is secure (Figure 5)

• Insert the U-Bolt through the slackline loop and push it down into the holes in the oval hole of the block

(Figure 6).

• Place washers over the ends of the u-bolt on the bottom of the block, and secure with the long nuts

giving only a couple twists (Figure 7).

• Repeat at the other end.

• When you have both ends completed you may start tightening the slackline by tightening the U-Bolts

using the Assembly Tool provided.

• DO NOT OVERTIGHTEN – IT MAY DAMAGE THE PRODUCT.

Figure 1

Figure 2

Figure 3

Figure 4

Figure 7

Figure 5

Figure 6

b4 Adventure • Denver Colorado 80216 • 1-844-834-4334 QUESTIONS? • [email protected] •