- ページ 30

ゲートウェイ Cisco DPC3848VMのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Cisco DPC3848VM 50 ページ。 Docsis 3.0 24x8 wireless residential gateway

Chapter 2 Installing the D OC SIS 3.0 W ireless Residential Gateway

Mounting the Wireless Residential Gateway on a Wall

Using a drill with a 3/16-inch bit, drill two holes at the same height and 4 inches

apart.

Note: The preceding graphic illustrates the location of the mounting holes on the

back of the residential gateway.

Are you mounting the residential gateway into a drywall or concrete surface

where a wooden stud is available?



If yes, go to Step 3.



If no, drive the anchor bolts into the wall, and install the mounting screws

into the anchor bolts; leave a gap of about 1/2-inch between the screw head

and the wall. Then, go to Step 4.

Install the mounting screws into the wall; leave a gap of about 1/2-inch between

the screw head and the wall. Then, go to Step 4.

Verify that no cables or wires are connected to the residential gateway.

Lift the residential gateway into position. Slip the large end of both mounting

slots (located in the side of the residential gateway) over the mounting screws,

and then slide the residential gateway down until the narrow end of the keyhole

slot contacts the screw shaft.

Important: Verify that the mounting screws securely support the residential

gateway before you release the unit.

OL-30544-01