- ページ 27

ゲートウェイ Cisco Expressway CE1200のPDF 家電製品設置マニュアルをオンラインで閲覧またはダウンロードできます。Cisco Expressway CE1200 42 ページ。
Cisco Expressway CE1200 にも：インストレーション・マニュアル (23 ページ)

ページを印刷する

Connect to Expressway Console

•

Connect to the Expressway Console

Before you can use the Expressway you need to configure some basic information by connecting to the

Expressway console and then completing the secure Install Wizard.

You can use either of these connection methods, as described below:

• Direct cabled connection from a PC to the Cisco Expressway serial port.

• Remote connection with the Cisco Integrated Management Controller (CIMC) tool using serial over

Before You Begin

1. Connect an Ethernet LAN cable from the LAN1 port on the rear panel to your network.

2. Have the following information ready for when the Install Wizard runs:

3. If you intend to use a CIMC connection these additional points apply:

a. You need an IP address for it, which can be static or DHCP-assigned.

b. You need a browser with the following minimum requirements:

Connect to the Expressway Console, on page 21

LAN.

• IPv4 and/or IPv6 address, subnet mask and default gateway address for the Expressway. Consult

your network administrator about which addresses to use. The Cisco Expressway must use a static

IP address.

• Suitable passwords for the predefined root and admin user accounts - use strong passwords for both

accounts.

• Java Runtime Environment 1.6 or later

• HTTP and HTTPS enabled

• Adobe Flash Player 10 or later

C H A P T E R

Cisco Expressway CE1200 Appliance Installation Guide (14.0)