- ページ 31

ゲートウェイ Cisco Expressway CE1200のPDF 家電製品設置マニュアルをオンラインで閲覧またはダウンロードできます。Cisco Expressway CE1200 42 ページ。
Cisco Expressway CE1200 にも：インストレーション・マニュアル (23 ページ)

ページを印刷する

Connect to Expressway Console

Task 2: Run CIMC from a remote host and enable Serial over LAN (once only)

Step 1

In a web browser, go to the CIMC IP address you configured in the previous task.

Step 2

Do one of the following:

• If you use a static IP address, log in using the password you set in Task 1.

Note

If the new password you set in Task 1 was not strong enough, because of the known issue with the system

failing to notify you at the time, you are now prompted to enter the default password and then to set a

different, strong, password before you can continue. The new password must match the conditions in

Connecting Using CIMC Serial Over

• If you use DHCP, define a strong password to replace the supplied default. The new password must match the

conditions in

Step 3

Click the menu arrow in the top-left corner.

Step 4

Navigate to Compute > Remote Management > Serial over LAN

Step 5

In the Serial over LAN Properties, check Enabled and then click Save Changes. This step is necessary as serial over

LAN is disabled by default.

Task 3: Connect to the Expressway console (any time you need to)

Step 1

In a terminal emulator, use SSH to connect to the CIMC IP address.

Step 2

Type the default username admin and your CIMC password, and press Enter.

Step 3

Type connect host and press Enter.

Step 4

You are now connected to the Expressway console using serial over LAN.

Wait for the Install Wizard to appear, and go to the section

Connecting Using CIMC Serial Over

Task 2: Run CIMC from a remote host and enable Serial over LAN (once only)

LAN.

Run the Install Wizard

Cisco Expressway CE1200 Appliance Installation Guide (14.0)