- ページ 11

ゲートウェイ Cisco Linksys WAG200GのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Cisco Linksys WAG200G 39 ページ。 Linksys wireless-g adsl home gateway

Cisco Linksys WAG200G ユーザーマニュアル
Chapter4
IP Settings
Select Obtan an IP Address Automatcally if your ISP
says you are connecting through a dynamic IP address.
If you are required to use a permanent (static) IP address
to connect to the Internet, then select Use the followng
IP Address. Your ISP provides the settings needed for the
following fields:
Internet IP Address
Enter the Gateway's IP address, as
seen from the Internet.
Subnet Mask
Enter the Gateway's Subnet Mask, as seen
from the Internet (including your ISP).
Default Gateway
Enter the IP address of the ISP server.
Prmary
(Requred)
and
DNS
Enter the DNS (Domain Name System) server IP
address(es) provided by your ISP. At least one is required.
Bridge Mode Only
If you are using your Gateway as a bridge, which makes
the Gateway act like a stand-alone modem, select Brdge
Mode Only. All NAT and routing settings are disabled in
this mode.
Internet Connection Type > Bridged Mode Only
Optional Settings
Some of these settings may be required by your ISP. Verify
with your ISP before making any changes.
Optional Settings
Host Name and Doman Name
to supply a host and domain name for the Gateway.
Some ISPs, usually cable ISPs, require these names as
identification. You may have to check with your ISP to see
if your broadband Internet service has been configured
with a host and domain name. In most cases, leaving these
fields blank will work.
MTU
MTU is the Maximum Transmission Unit. It specifies
the largest packet size permitted for Internet transmission.
Wreless-G ADSL Home Gateway
Secondary
(Optonal)
These fields allow you
Advanced Configuration
Select Manual if you want to manually enter the largest
packet size that is transmitted. To have the Gateway select
the best MTU for your Internet connection, keep the
default, Auto.
Sze
When Manual is selected in the MTU field, this option
is enabled. Leave this value in the 1200 to 1500 range. The
default, MTU is configured automatically.
Network Setup
The Network Setup section changes the settings on the
network connected to the Gateway's Ethernet ports.
Wireless setup is performed through the Wireless tab.
Router IP
The values for the Gateway's Local IP Address and Subnet
Mask are shown here. In most cases, keeping the default
values will work.
Router IP
Local IP Address
The default value is 192.18.1.1.
Subnet Mask
The default value is 2.2.2.0.
Network Address Server Settings (DHCP)
The settings allow you to configure the Gateway's Dynamic
Host Configuration Protocol (DHCP) server function. The
Gateway can be used as a DHCP server for your network.
A DHCP server automatically assigns an IP address to each
computer on your network. If you choose to enable the
Gateway's DHCP server option, make sure there is no
other DHCP server on your network.
Network Address Server Settings (DHCP)
DHCP Server
A Dynamic Host Configuration Protocol
(DHCP) server automatically assigns an IP address to each
computer on your network for you. Unless you already
have one, Linksys recommends that you keep the default,
Enable. You can also use the Gateway in DHCP Relay
mode. (This setting is not available for all encapsulation
types.)
DHCP Relay
To use the Gateway in DHCP Relay mode
instead of using it as a DHCP server, select this option.
10