- ページ 19

ゲートウェイ Cisco Linksys WAG325NのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Cisco Linksys WAG325N 50 ページ。 2.4ghz wireless-n adsl2+

Wireless-N ADSL2+ Gateway

• Pcr Rate: For the Peak Cell Rate, divide the DSL line rate by 424 to get the maximum rate the sender can

send cells. Enter the rate in the field (if required by your service provider).

• Scr Rate: The Sustain Cell Rate sets the average cell rate that can be transmitted. The SCR value is

normally less than the PCR value. Enter the rate in the field (if required by your service provider).

• Autodetect: Select Enable to have the settings automatically entered, or select Disable to enter the

values manually.

• Virtual Circuit: These fields consist of two items: VPI (Virtual Path Identifier) and VCI (Virtual Channel

Identifier). Your ISP will provide the correct settings for these fields.

• DSL Modulation: Select the appropriate mode: MultiMode, T1 .413, G.dmt, G.lite, ADSL2, or ADSL2+.

Contact your ISP if you are not sure which mode to use.

• IP Settings. Follow the instructions in the section for your type of encapsulation.

RFC 1483 Bridged

Dynamic IP

IP Settings. Select Obtain an IP Address Automatically if your ISP says you are connecting through a

dynamic IP address.

Static IP

If you are required to use a permanent (static) IP address to connect to the Internet, then select Use the

following IP Address.

• Internet IP Address. This is the Gateway's IP address, when seen from the WAN, or the Internet. Your ISP

will provide you with the IP Address you need to specify here.

• Subnet Mask. This is the Gateway's Subnet Mask. Your ISP will provide you with the Subnet Mask.

• Default Gateway. Your ISP will provide you with the default Gateway Address, which is the ISP server's IP

address.

• Primary DNS (Required) and Secondary DNS (Optional). Your ISP will provide you with at least one DNS

(Domain Name System) Server IP Address.

Chapter 5: Configuring the Wireless-N ADSL2+ Gateway

The Setup Tab

Figure 5-2: RFC 1483 Bridged