- ページ 6

スキャナー Epson Perfection V350 SeriesのPDF 通知と保証をオンラインで閲覧またはダウンロードできます。Epson Perfection V350 Series 29 ページ。 Product support bulletin(s)
Epson Perfection V350 Series にも： ユーザーマニュアル (11 ページ), クイックスタート (4 ページ), 重要な安全上のご注意 (4 ページ), 補足マニュアル (2 ページ), 製品サポート速報 (23 ページ), 更新 (1 ページ), 製品サポート速報 (40 ページ), 製品サポート速報 (24 ページ), 製品サポート速報 (29 ページ), 製品サポート速報 (8 ページ), 製品サポート速報 (3 ページ), 製品サポート速報 (11 ページ), 製品サポート速報 (14 ページ), 製品サポート速報 (12 ページ), 製品サポート速報 (40 ページ), 製品サポート速報 (11 ページ), 製品サポート速報 (40 ページ), 製品サポート速報 (22 ページ), 製品サポート速報 (12 ページ), 製品サポート速報 (21 ページ), 製品サポート速報 (12 ページ), ここからスタート (2 ページ), ここからスタート (4 ページ), ここからスタート (2 ページ), ここからスタート (2 ページ)

ページを印刷する
Epson Perfection V350 Series 通知と保証
AC Adapter
EMC
European model:
Low Voltage Directive
73/23/EEC EMC
Directive 89/336/EEC

FCC Compliance Statement

For United States Users
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio or television reception. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause
interference to radio and television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
■
Reorient or relocate the receiving antenna.
■
Increase the separation between the equipment and receiver.
■
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
■
Consult the dealer or an experienced radio/TV technician for help.
WARNING: The connection of a non-shielded equipment interface cable to this equipment will
invalidate the FCC Certification of this device and may cause interference levels which exceed the
limits established by the FCC for this equipment. It is the responsibility of the user to obtain and
use a shielded equipment interface cable with this device. If this equipment has more than one
interface connector, do not leave cables connected to unused interfaces. Changes or modifications
not expressly approved by the manufacturer could void the user's authority to operate the
equipment.
For Canadian Users
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing
Equipment Regulations.
Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le materiel brouilleur
du Canada.
6
FCC Part 15 Subpart B Class B
CAN/CSA-CEI/IEC CISPR 22 Class B
EN 60950-1
EN 55022 Class B
EN 55024
EN 61000-3-2
EN 61000-3-3