- ページ 15

ゲートウェイ Cisco VG202のPDF ソフトウェア設定マニュアルをオンラインで閲覧またはダウンロードできます。Cisco VG202 50 ページ。 Voice gateways
Cisco VG202 にも：ハードウェア・インストール・マニュアル (50 ページ), マニュアル (10 ページ), ハードウェア・インストール・マニュアル (48 ページ), クイック・スタート・マニュアル (19 ページ)

Using the setup Command Facility

This chapter describes how to use the setup command facility to configure your Cisco voice gateway

(VG). The setup command facility prompts you to enter information needed to start a VG functioning

quickly. The facility steps you through a basic configuration, including LAN interfaces.

This chapter presents the following major topics:

•

If you prefer to configure the VG manually or if you wish to configure a module or interface that is not

included in the setup command facility, proceed to

Interface,"

Cisco VG202 and VG204 voice gateways ship with default configuration. During the first boot up, the

Note

Cisco VG202 and VG204 voice gateways will not enter setup mode and will be configured through

auto-configuration.

If you prefer to configure the VG using AutoInstall, see the

Cisco Networking Devices

Before you power on your Cisco voice gateway and begin to use the setup command facility, follow

these steps:

Set up the hardware as described in the hardware installation documents for your Cisco VG.

Step 1

Configure your PC terminal emulation program for 9600 baud, 8 data bits, no parity, and 1 stop bit.

Step 2

Determine which network protocols you are supporting.

Step 3

Step 4

Determine the following for each network protocol:

•

OL-16191-01

Before Powering On Your Cisco Voice Gateway, page 2-1

Using the setup Command Facility, page 2-2

Configuring Global Parameters, page 2-2

Completing the Configuration, page 2-5

for step-by-step instructions.

document.

Addressing plan

Cisco VG202 and Cisco VG204 Voice Gateways Software Configuration Guide

C H A P T E R

"Chapter 3, "Configuring with the Command-Line

Using AutoInstall to Remotely Configure

2-1