- ページ 5

ガレージドアオープナー Digiway SW50のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Digiway SW50 5 ページ。 Dual motor controller
Digiway SW50 にも：取扱説明書 (14 ページ)

To restore factory setting, turn power off and set DIP1 on, push and hold CLS

button, then power on. While hold CLS button, set DIP1 off and then release the

CLS button. Now controller restored factory setting from memory.

2.6. Two wires Motors

Two wires motor, need diode serial with motor, as the following drawing.

2.7. Five Wires motors

Five wires motor drawing as the drawing.

3.1 Connection of torque motors

The motor outputs of control board are directly connected to torque motors. Ignore all limit switch

inputs. In this application, OPN open two boom gates while PED open M1 driven boom gate. For

the details connect see the diagram.

2.8. Two wires motors without limit switch (V1.0 software does not have this function.)

3 Trouble shooting guide

3.1 General checking

Normally if installation is done properly, there would be trouble free. If in case of malfunction, please

checking as following steps.

1) Check the DIP setting motor selection is right.

2) Gate status LED green (open) and red (close), one or both should be flashing depending on the gate

position. If not flashing, please check the power supply and 12V DC output circuits if there is a short

circuits.

3.2 Gate not open

1) Check the limits switch type selection if it is right.

2) Push button on the control board, if gate status green LED flashing and red LED off, please check

motor fuse and motor.

3.3 Gate not close

1) Check the limits switch type selection if it is right

2) Check the DIP switches auto close mode selection if it is right.

3) Check control input. If one or more of OPN, OSC, PED input LED are on, which means access

control system hold gate open.

4) If PEB input LED is not on, which means PE beams is faulty or blocked. Meanwhile can hear 4

beeps

- 5 -