- ページ 6

GPS TomTom GOのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。TomTom GO 21 ページ。 5” gps with built-in bluetooth
TomTom GO にも：ユーザーマニュアル (19 ページ), パンフレット＆スペック (7 ページ), ユーザーマニュアル (36 ページ), クイック・スタート・マニュアル (22 ページ), マニュアル (29 ページ), クイック・スタート・マニュアル (16 ページ), クイック・スタート・マニュアル (40 ページ), 知る (5 ページ)

ページを印刷する

Installation

Assembly

1. Assemble the suction-mount cradle as

shown in the installation poster.

2. Plug the small plug end of the DC power

lead into the socket on the back of the

cradle. Plug the other end into your vehi-

cle's 12V (cigarette lighter) socket.

3. Ease TomTom GO onto its cradle by loca-

ting its front edge first and then pushing

back firmly until you hear a click. You'll

feel TomTom GO lock into place. The

green LED on TomTom GO's front panel

will light up if the cradle is also connected

to your vehicle's 12V socket.

4. Clean the inside of your windshield (or

side window), to remove any dust and

grease. Place the cradle in a suitable

location on your windshield and push the

black plastic lever to the right, fixing the

cradle in position.

NOTE: Some newer vehicles may have a heat reflec-

tive shield embedded in the windshield. In some

cases this can prevent proper GPS signal reception.

If this turns out to be a problem in your vehicle,

you will need to purchase and install the TomTom

External Antenna Kit (available as an accessory).

Tip: You don't have to use the cradle if you don't want

to. If necessary, TomTom GO can be positioned on its

own anywhere that's convenient, provided that it's safely

secured.

Under normal travelling conditions, the

suction mount is sufficient to hold the cradle

3.6959_TT_Malaga_USA.def.indd 6

in position. Note that suction may be lost if

left overnight, due to condensation and low

temperature. For this reason, and for security,

we recommend removing both the suction

mount cradle and TomTom GO when leaving

your vehicle overnight. To remove the cradle,

pull the suction mount lever to the left. If the

cradle still doesn't detach from your wind-

shield, tug gently on the clear plastic tab at

the edge of the suction mount, to break the

vacuum seal.

Tip: To activate your 12V socket, you may need to set

your ignition key in an 'Accessories' position. Please

consult your vehicle handbook. Also, TomTom GO con-

tains a rechargeable battery which can be used for up

to 4 hours without charging. For short trips it may be

possible to do without the DC power lead for simpler

and neater operation.

To adjust the angle of TomTom GO, loosen

the adjustable knobs on the cradle and then

turn it gently. In addition to tilting the cradle

up and down and from side to side, you can

also rotate TomTom GO in the cradle, from

left to right, ±45°. When you're happy, tighten

up the knobs again.

Tip: After using TomTom GO, remove it from the cradle

by pressing the release button while tipping the unit

forward gently. Put it in the supplied bag. If you want

to clean it, use a soft, dry cloth. Do not use water or a

solvent

04-04-2005 12:50:53