- ページ 28

プリンターアクセサリー Epson FX-880+のPDF クイックマニュアルをオンラインで閲覧またはダウンロードできます。Epson FX-880+ 33 ページ。 Epson serial impact dot matrix printers
Epson FX-880+ にも：セットアップマニュアル (33 ページ), パンフレット＆スペック (24 ページ), マニュアル (18 ページ), 仕様 (2 ページ), 最初にお読みください (2 ページ), リファレンス・マニュアル (34 ページ)

ページを印刷する

Adjusting the top-of-form position

The top-of-form position is the position on

the page where the printer starts printing. If

your printing appears too high or low on the

page, you can use the Micro Adjust function

to adjust the top-of-form position.

Follow these steps to adjust the top-of-form

position:

Caution:

Never use the knob to adjust the

top-of-form position; this may damage the

printer or cause it to lose the top-of-form

position.

Note:

❏ Your top-of-form position setting remains in

effect until you change it, even if you turn off

the printer.

❏ The top margin setting made in some

application software overrides the

top-of-form position setting you make with

the Micro Adjust function. If necessary,

adjust the top-of-form position in your

software.

1. Make sure the printer is turned on.

2. Load paper. (If the tractor is in a push

position, press the Load/Eject button to

advance continuous paper to the current

top-of-form position.) If necessary, lift

up the printer cover so you can see the

paper position.

3. Hold down the Pause button for about

three seconds. The Pause light starts

flashing and the printer enters the Micro

Adjust mode.

Downloaded from:

http://www.usersmanualguide.com/

EPSON FX-880+/FX-1180+ Quick Guide

4. Press the LF/FF D button to move the

top-of-form position up on the page, or

press the Load/Eject U button to move

the top-of-form position down on the

page.

Note:

❏ The printer has a minimum and a

maximum top-of-form position. If you

try to adjust it beyond these limits, the

printer beeps and stops moving the

paper.

❏ When the paper reaches the default

top-of-form position, the printer also

beeps and stops moving the paper

briefly. You can use the default setting

as a reference point when adjusting the

top-of-form position.

5. After you set the top-of-form position,

press the Pause button to exit the Micro

Adjust mode.

Micro Adjust Function (2/2)