- ページ 17

プリンターアクセサリー Epson GQ-3500のPDF 製品サポート速報をオンラインで閲覧またはダウンロードできます。Epson GQ-3500 20 ページ。 Product support bulletin(s)
Epson GQ-3500 にも：ユーザーマニュアル (13 ページ), 製品サポート速報 (3 ページ), 製品サポート速報 (27 ページ), 製品サポート速報 (8 ページ), 製品サポート速報 (14 ページ), 製品サポート速報 (25 ページ), 製品サポート速報 (13 ページ), 製品サポート速報 (2 ページ)

Q5.

How do I run a SELF- TEST on the EPL- 6000?

The EPL- 6000 provides (3) three built - in SELF-TESTS. In order to activate

any of the built- in SELF -TESTS the printer must be set to "OFF - LINE".

Listed below are the keystrokes necessary to press to initiate the SELF-

TESTS.

time.

Q6.

After I make changes in SelecType what must I do to activate these changes?

After making the necessary changes in SelecType press the "SELECTYPE"

button to exit SelecType, the LCD will display "OFF- LINE". At this point

press and hold the "RESET/CONTINUE" button for approximately 3 seconds.

When the printer displays "RESET" on the LCD display, the button should be

released. The SelecType changes you made have now been saved.

NOTE:

are changed the printer must also be powered "OFF" then back "ON" in order

for these changes to become active.

SELF TEST - Press the "SPECIAL" and "MANUAL" buttons at the same

(Used to print out a test pattern that is helpful when adjusting or

checking the print darkness.

a basic determination of whether the printer is functional.)

FONT PRINT - Press the "SPECIAL" and "RESET/CONTINUE" buttons

at the same time.

(Used to print out information and print samples on available fonts,

including built- in fonts, cartridge fonts and downloaded (soft) fonts.)

STATUS PRINT - Press the "UP" and "DOWN" arrow buttons at the

same time.

(Used to determine the printer's current settings, such as font source

and number, symbol set, paper size, orientation and data buffer

configuration.)

lf the INTERFACE, DATA BUFFER, or OVERLOAD BUFFER settings

PSB No: P - 0058A

Page: 2 of 5

This test may also be used to provide