3.1 OVERVIEW
This section describes procedures for disassembling the main components of the EPSON Stylus COLOR
400. Unless otherwise specified, disassembled units or components can be reassembled by reversing the
disassembly procedure. Therefore, no assembly procedures are included in this section. Precautions for any
disassembly or assembly procedure are described under the heading "Points to Note." Adjustments required
after disassembling the units are described under the heading "Required Adjustment."
3.1.1 Precautions for Disassembling the Printer
See the precautions below when disassembling or assembling EPSON Stylus COLOR 400.
;
Disconnect the power cable before disassembling or assembling the printer.
;
Wear goggles to protect your eyes from ink. If ink gets in your eye, flush it with fresh water and see a
doctor immediately.
;
If ink comes into contact with your skin, wash it off with soap and water. If irritation occurs, contact a
physician.
;
A lithium battery is installed on the main board of this printer. Be sure to observe the following
instructions when servicing the battery:
Keep the battery away from any metal or other batteries so that electrodes of the opposite
polarity do not come in contact with each other.
Do not heat the battery or put it near fire.
Do not solder on any part of the battery. (Doing so may result in leakage of electrolyte from the
battery, burning, or explosion. The leakage may affect other devices close to the battery.)
Do not charge the battery. (An explosion may be generated inside the battery, and cause burning
or explosion.)
Do not dismantle the battery. (The gas inside the battery may hurt your throat. Leakage, burning,
or explosion may also result.)
Do not install the battery in the wrong direction. (This may cause burning or explosion.)
;
Danger of explosion if the battery is incorrectly replaced. Replace only with the same or equivalent
type recommended by the manufacturer. Dispose of used batteries according to government ' s law
and regulations.
Risque d ' explosion si la pile est remplac é e incorrectment. Ne remplacer que par une pile du m ê me type
ou d ' un type é quivalent recommand é par le fabricant. Eliminer les piles d é charg é es selon les lois et les
r è gles de s é curit é en vigueur.
EPSON Stylus COLOR 400 Service Manual
WARNING
Disassembly and Assembly
3-1
ページを印刷する