Installing in Windows 3.1
Follow these steps to install the software in Windows 3.1.
1.
Make sure Windows 3.1 is running and the Program Manager window
is open.
2.
Insert the printer software CD shipped with your printer in the CD-
ROM drive. (If you use the floppy disk version, insert it in a disk drive.)
3.
Choose Run from the File menu. The Run dialog box appears. In the
Command Line box, type D:SETUP and click OK. If the CD-ROM drive
has a drive letter other than "D" or if you are using the floppy disk
version, substitute the appropriate letter.
4.
The installation program begins copying the printer software files.
5.
When the installation is complete, click OK to exit the installation
program.
The installation program automatically selects this printer as the default
printer for Windows applications.
Installing the Ink Cartridges
Using the setup utility for Windows 95, 98, and NT 4.0
If you have Windows 95, 98, or NT 4.0 installed on your computer, the Setup
utility should open automatically when your printer software installation
is complete. Follow the on-screen instructions to complete the setup and
proceed to step 7, "Printing Your First Page".
The Setup utility cannot be accessed by Windows 3.1 and Macintosh users.
Please refer to the following section, "Using the Printer's control panel" and
to step 6, "Checking the Printer" for instructions on completing the setup
using the printer's control panel.
Using the printer's control panel
When you can not access the setup utility, use the printer's control panel to
install the ink cartridge.
Before installing the ink cartridges, note the following.
w
Warning:
The ink cartridges are self-contained units. Under ordinary use, ink will
not leak from a cartridge. If ink does get on your hands, wash them
thoroughly with soap and water. If ink gets into your eyes, flush them
immediately with water.