- ページ 3

制御システム Dill 1502のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Dill 1502 16 ページ。 Tpms trailer kit

1.0 Setting Up the System

Have a professional tire retailer install the valves with transmitters in the

wheels. See section 2 for details. Each transmitter has a unique ID and

needs to be installed in the same corresponding position as noted in

Figure on page 13.

1.2.1

Install the supplied antenna to your display unit located at the back of

the unit.

1.2.2 Use the display mount to affix the display unit on the windshield or

dashboard. Do not block the driver's view. Adjust the viewing angle

of the display, if necessary.

1.2.3 Plug the power cord into the display unit and plug the adapter into

auxiliary power supply or hardware to vehicle electrical system.

NOTE:

For hardwired connection, black wire is ground and red is positive.

1.2.4 If your tire cold inflation pressure is 35 psi, you are done. If it is

something besides 35 psi, complete section 1.3.

1.3.1 Set the pressure in all tires to the recommended cold inflation

pressure.

1.3.2 Plug the power cord into the display unit and plug the adapter into

auxiliary power supply.

FIGURE 1

1.3.3 Hold down the "R/D" button until

you hear a beep.

1.3.4 Press and release the "SET" button.

The display will show "dd" in place

of the pressure readings.

FIGURE 2