- ページ 2

バーコードリーダー Argox AI-6821のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Argox AI-6821 14 ページ。

How to set up your scanner

1. Connect the USB or the RS-232 cable to your

cradle. Lay the cable into the notch on the

cradle edge.

2. Connect the USB or the RS-232 cable to your

computer.

Note 1 If you've purchased the USB pack, you

can charge your scanner by connecting the USB

cable to your computer. You can also charge it

by connecting a power supply (optional) to your

USB cable. The charging time is shorter with a

power supply.

Note 2 If you've purchased the RS-232 pack,

connect the power supply to the RS-232 cable

and the wall outlet.

Charging by

Power Supply

USB Cable

3. Place your scanner on your cradle to charge it to

full (cradle's LED glows green).

4. Scan the Data Matrix code at the bottom of

your cradle to establish the connection between

your scanner and cradle.

5. To test your scanner, start a text processing

program like Notepad or Word. Scan a bar code

and see if the data can be sent to your computer.

If it's successful, you'll hear a beep and the bar

code data shows in the program.

Reset your Scanner

Scan the following bar code to restore your

scanner to factory settings.

Option

Description

Reset

Restore your

your

scanner to factory

scanner

settings.

Decode only the bar codes aligned under the

center of the aiming pattern.

Full Charge Time

3 hours

4.5 hours

Bar Code