- ページ 14

計測機器 AEMC instruments CA7027のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。AEMC instruments CA7027 20 ページ。 Fault mapper pro graphical tdr
AEMC instruments CA7027 にも：ユーザーマニュアル (20 ページ)

ページを印刷する

3. Connect one end of the cable to the Fault Mapper Pro

unterminated and make sure the wires do not short to each other.

4. Measure the length and adjust the Vp until the exact length is displayed.

5. When the exact length is displayed, Vp is established.

4.10 Attaching a Cable to the Fault Mapper Pro

1. Check that the far end of the cable is either open or shorted (not fitted

with a resistive termination).

2. Attach the Fault Mapper Pro

The cable attachment is via a banana plug input located at the top of the

unit. For unterminated cables use the alligator clip attachment provided.

Coaxial Cable:

Shielded Cable: Connect the Red clip to a wire adjacent to the

Twisted Pair:

Multi-conductor Cable: Connect the clips to any two wires.

Find Quality Products Online at:

All manuals and user guides at all-guides.com

WARNING: Make sure that there is no power supply or equipment attached

to the cable to be tested.

Connect the Red clip to the center wire and the

Black clip to the shield/screen.

shield and the Black clip to the shield.

Separate out one pair and connect the red and black

clips to the two wires of the pair.

GlobalTestSupply

www.

to one end of the cable to be tested.

Coaxial Cable

Shielded Cable

Twisted Pair

Multi-conductor Cable

Fault Mapper Pro

.com

. Leave the end

Model CA7027

[email protected]