- ページ 6

アンプ Crown DriveCore XLS 2502のPDF 操作マニュアルをオンラインで閲覧またはダウンロードできます。Crown DriveCore XLS 2502 20 ページ。 Xls drivecoretm 2 series

ページを印刷する

Front Panel Features

Cooling Vents:

Front to rear forced air ﬂow.

Gain (Level) Controls:

Two black rotary level controls,

one for each channel.

Back Panel Features

Circuit Breaker:

Provides overload protection.

AC Power

AUX Connector

Allows sleep mode

Connector

with a contact closure

between pins 1 & 2.

Amp status signal

available at pin 3.

page 6

Indicators:

Signal Presence Indicator: Two green LED's, one for each channel, illuminate when the channel input

signal exceeds -40dBu.

-20 Indicator: Green LED ﬂashes when output signal level exceeds -20dB below clip.

-10 Indicator: Green LED ﬂashes when output signal level exceeds -10dB below clip.

Clip Indicator: Two red LED's, one for each channel, illuminate when the channel's output is being overdriven.

Thermal Indicator: Two red LED's, one for each channel, illuminate when thermal compression begins.

Menu/Prev/Next:

Three buttons located near the

LCD screen that are used to

conﬁgure and access the

integrated processing.

Binding Post Output Jacks:

One pair per channel, accepts banana plugs or

bare wire. Note: Binding post outputs on European

models come with safety plugs installed to prevent

European power plugs from being inserted. The

side entry positions for these connectors should

be used with European models.

4-Pole Speakon

Two - 1/4 inch input connectors accept 2-pole or

4-pole Speakon connectors. The Channel 1

connector is wired for both channels so it can be

used for BRIDGE mode wiring or stereo wiring of

two speakers to a single Speakon.

XLS DriveCore 2 Series Power Amplifiers

LCD Screen:

Back-lit LCD screen allows for

crossover conﬁguration,

ampliﬁer mode conﬁguration,

and system conﬁguration.

Fans:

Provide front to back

forced air ow for cooling.

Output Connectors:

Power Button

Turns ampliﬁer power on and off.

RCA (Phono) Inputs:

Two RCA inputs are provided

(one per channel).

¼ Inch Inputs:

Balanced XLR Inputs:

2 – ¼ Inch input connectors

Two 3-pin XLR input

are provided (one per

connectors are provided

channel). These inputs can

(one per channel).

also be used to loop-thru

signal to additional ampli ers.

Operation Manual

Blue LEDs:

LEDs will illuminate when

power is turned on or blink

while in sleep mode.