- ページ 31

双方向ラジオ Motorola APX 5000のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Motorola APX 5000 45 ページ。 Digital portable radios
Motorola APX 5000 にも: クイック・リファレンス・カード (2 ページ), クイック・リファレンス・カード (2 ページ), クイック・リファレンス・カード (2 ページ), クイック・リファレンス・カード (2 ページ)

Motorola APX 5000 ユーザーマニュアル

Efficient System Operation

Do not operate your APX VA unless all RF connectors are properly
terminated.
All equipment must be properly grounded according to Motorola's
installation instructions for safe operation.
All equipment should be serviced only by an authorized technician.

Troubleshooting

LED Connection Error Behavior from APX VA Installer Viewpoint:
Note: Ensure that vehicle ignition is on, surveillance mode disabled, and
Engage Button fully depressed to facilitate troubleshooting.
Condition
The LED lights solid purple
when the radio is turned on,
and displays charging status
when the radio is turned off.
The radio will not detect the
APX VA.
The lights solid purple when
the radio is turned on, and
displays charging status when
the radio is turned off. The
radio will not detect the APX
VA.
The LED lights solid purple
when the radio is turned on.
The APX VA will disconnect
itself from the radio.
The LED lights solid purple
when the radio is turned on,
and displays charging status
when the radio is turned off.
The radio will not detect the
APX VA.
Description
Neither a hand mic, nor a
Visor Mic is connected
prior to turning the radio
on.
There is an unsupported
IMPRES accessory
connected to the
Microphone connector on
the APX VA prior to turning
the radio on.
A hand mic or Visor Mic is
added or removed after
the radio is turned on.
When the radio is turned
on, there is no
unsupported IMPRES
accessory present, and
there is a supported hand
mic or Visor Mic present,
but the LED lights solid
purple.
Remedy
1. Turn the radio off.
2. Connect at least one
microphone accessory.
3. Turn the radio on.
4. The LED will show charging
status in a few seconds.
1. Turn the radio off.
2. Remove the unsupported
accessory and possibly attach
a supported one.
3. Turn the radio on.
4. The LED will show charging
status in a few seconds.
1. Turn the radio off.
2. Turn the radio on.
3. If there is at least one
microphone accessory, the
LED will show charging status
within a few seconds. If there
is no attached accessory, this
is covered by the case in
which no mic is attached.
If at least one microphone
accessory is correctly connected,
and no unsupported accessory is
connected, then there is a
problem with the connection, the
accessory, or the APX VA. The
accessory or the APX VA may
require factory service.
29