- ページ 5

双方向ラジオ Motorola DPSのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Motorola DPS 10 ページ。 Motorola owner's manual talkabout distance dps

ページを印刷する

Batteries

The Ni-Cad battery ships uncharged, it must

be fully charged for 16 hours before use (ﬁrst

charge only). It is recommended that only

Motorola batteries and chargers be used with

the radio.

The Ni-Cad rechargeable battery pack will

provide approximately 8 hours of operation

with normal use (5% sending messages, 5%

receiving messages and 90% in standby

mode).

Low Battery Alert

When the battery is low, the radio will beep:

• 3 to 4 seconds after turning power on

• Every 10 minutes in standby mode

• After release of the Push-To-Talk button

Recharge the battery pack immediately to

avoid interrupted use.

Note: Remove battery pack before storing

your radio for extended periods. Batteries

may corrode over time if left in radio and can

cause permanent damage to your radio.

FIG. D

To Install/Remove Ni-Cad

Battery

Note: Radio must be OFF before installing/

removing battery.

1. Push back both battery cover latches until

you see the orange tabs.

2. Slide battery cover down and lift to remove.

Fig. D

3. Insert the battery pack with arrows pointing

towards the top of the radio. Fig. E

4. Replace battery cover and lock latches.

5. To remove battery, remove cover, turn the

radio over and tap the battery end of the

radio against the palm of your hand. The

battery will drop into your hand. Fig. F

Note: Do not remove the plastic wrap from

the battery pack. This will permanently dam-

age the battery.

FIG. F

FIG. E

To Charge Ni-Cad Battery

1. Turn the radio off.

2. Lift accessory cover and plug the Charger

Adapter ﬁrmly into the small jack (lower

hole).

3. Plug the charger into an electric outlet. The

light on the charger will glow continuously

if charging properly.

4. Allow 10 hours for the battery to fully

charge.

Notes:

• For optimum battery life, the battery

should not be left charging for prolonged

periods after reaching full charge. Charg-

ing the battery over the weekend is

acceptable.

• Turn radio off when charging. If radio is

on while charging, at least twice as much

time is required to charge the battery.

FIG. G

Installing Alkaline Batteries

For DPS Model

Your TalkAbout Distance DPS radio has the

option of operating with either a Ni-Cad bat-

tery pack or 6 AA alkaline batteries. Alkaline

batteries will last about 25 hours with normal

use. That's approximately 5% sending mes-

sages, 5% receiving and 90% in standby

mode.

To Install Alkaline Battery Tray

1. Unlock battery cover latches and remove

battery cover and Ni-Cad battery pack.

2. Remove Ni-Cad tray by squeezing latch on

bottom of tray and lift out. Fig. G

3. Align the tabs on the top and sides of the

alkaline battery tray with the slots in the

radio. Contacts on battery tray should

match contacts with radio. Fig. H

4. Press bottom of battery tray into radio.

To Remove Alkaline Battery Tray

1. Holding radio as shown in Fig. I, press

thumb on top of alkaline tray to pop bottom

edge out of radio.

2. Grasp the bottom edge of the tray and pull

it out of the radio.

FIG. I

FIG. H