- ページ 37

双方向ラジオ Motorola GP240のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Motorola GP240 46 ページ。 Professional radio, power distribution and controller
Motorola GP240 にも：サービス情報 (32 ページ), サービス情報 (30 ページ), ユーザーマニュアル (46 ページ), サービス情報 (30 ページ)

ページを印刷する

Note: The call received status annunciator, F,

flashes when you receive a call, but is not

displayed when you answer the call.

Making a Telephone Call

(GP280 radios only)

There are three phases in making a phone call,

namely

• accessing the telephone system,

• sending the telephone number,

• having the conversation and hanging-up.

Accessing the Telephone System

1. Press / until PHON

is displayed.

2. Press l (the softkey below PHON).

3. Your radio attempts to access the telephone

system.

4. If you connect successfully, you will hear a dial

tone.

5. The display will show the

last number dialed.

Sending the Telephone Number

Sending the telephone number using the keypad

6a. The number can now be entered from the

6b. If your radio is programmed for "live dial,"

MSG

SCAN PHON

6c. The telephone number will be sent out; you

5551135

keypad, using any of the numeric (0 – 9) keys,

and the "*" and "#" keys. The cursor flashes to

indicate the location of the next digit to be

entered. A pause can be entered in the

telephone number by first pressing the "*" key,

then the "#" key (Buffered dial only - The

pause will be shown on the display as a "P").

each digit is sent out as its key is pressed.

—or—

If your radio is programmed for "buffered dial,"

each digit is temporarily stored as you enter

them. After entering the number, press the

PTT switch to send out the number.

will hear tones as they are sent. If you hear a

busy signal, go to step 8 for hang-up

procedure.

English