- ページ 4

室内装飾品 diLUSSO WD200SSSのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。diLUSSO WD200SSS 8 ページ。 Built-in warming drawer

Installation Instruction
Product & cutout dimensions for
WD200SSS
WD200BBS
l
Fit the appliance into its cabinetry by inserting screws into the 4 holes that can be seen in the frame
of the warming drawer when the door is open.
l
The warming drawer needs a supporting surface underneath. The sides and the face surface where
the warming drawer is to be installed should be milled to allow sufficient air intake and circulation
around the oven, to avoid causing any damage to the furniture.
l
Ensure the oven in secured firmly in place as described above, and insulate electrical connections in
order to avoid contact with metallic parts. The adhesive joining the rolled sections to the cabinet
has to withstand temperatures no lower than 90
l
For the most efficient air circulation, the warming drawer should be fitted according to the
dimensions shown. The rear panel of the cabinet must be removed so that air can circulate freely.
The panel to which the warming drawer is fitted should have a gap of at least
l
The warming drawer should be installed in a position which is at least 20mm away from other heating
appliances.
Do not switch on the appliance before it has been fully and correctly installed.
WARNING: The power socket must be connected to a switch with earth leakage protection. If the power
cable is damaged, please contact a qualified electrician for replacement.
Before using the warming drawer, we suggest to:
l
Remove the special film covering the warming drawer door glass (if there is any)
l
Heat the empty warming drawer at max. temperature for 45 minutes. This is to remove any
unpleasant smell caused by working residues.
V 1.0
to avoid deformations or instability.
Page 3
Installation Rubber
4X29 self tapping screw
80 - 90 mm
at the rear.