- ページ 13

デスクトップ Epson Endeavor WGのPDF 製品サポート速報をオンラインで閲覧またはダウンロードできます。Epson Endeavor WG 15 ページ。 Using with ms windows 3.x stylus 400/800+/color printer driver
Epson Endeavor WG にも: 製品サポート速報 (17 ページ), 製品サポート速報 (3 ページ), マニュアル (9 ページ)

Epson Endeavor WG 製品サポート速報
STB Systems WIND/X video adapter gives no display using default
5.
settings.
Resolution: A temporary solution is to change the WIND/X jumper J3
to select 8-bit instead of 16-bit VGA BIOS. A permanent solution is
under investigation.
When the slow speed is set via SETUP, SIMM memory is not
6.
recognized.
Resolution: BIOS version 1.02.1.03.
7.
In a server configuration, when the slow speed is set via keyboard
(CTRL-ALT-minus) and the NetWare 3.11 SERVER.EXE program is
executed, the system hangs.
Resolution: Under investigation. Probable BIOS revision required.
Too many invalid commands cause AutoCAD's Phar memory manager
8.
to fail. It will usually display the message "Heap stack error". At this
point, AutoCAD may fail or terminate, dropping back out to DOS.
Resolution: BIOS version 1.02.1.03.
Streaks or lines may appear on the screen when using Windows 3.0 or
9.
3.1 applications in standard VGA mode. This is not noticeable during
Windows installation.
Resolution: For configurations that have Windows 3.1 preinstalled, the
default display setting will be the Wingine 640 x 480 x 256 color driver,
so the problem will not occur. For other configurations, the appropriate
Wingine display driver should be installed, following the procedure in
the Progression VGA Utilities Guide. A permanent solution is under
investigation, and may be provided by a system board revision.
Flash BIOS version 1.02.1.03 may be downloaded from file library BIOS on
the Epson Bulletin Board System (310-782-4531). The filename is
102103.ZIP and it contains the BIOS code, the FLASHLDR.EXE program
and a text file of instructions. Download with protocol and extract with
PKUNZIP version 1.10 or later. Copy the extracted files to a clean MS-DOS
boot diskette, boot the system with that diskette and run FLASHLDR.
PSB No: S-0152A
Page: 2 of 2