- ページ 3

デスクトップ Epson Equity 386SX PLUSのPDF 製品サポート速報をオンラインで閲覧またはダウンロードできます。Epson Equity 386SX PLUS 26 ページ。 Product support bulletin(s)
Epson Equity 386SX PLUS にも：製品サポート速報 (19 ページ), 製品情報マニュアル (10 ページ), 製品情報マニュアル (10 ページ), 製品サポート速報 (45 ページ)

ページを印刷する

Product Support Bulletin

Subject:

The Equity 386SX PLUS Diskless Workstation - lnstalling Optional

Equipment

Date: 3/7/91

Page(s): 1 of 3

WORKSTATION INSTALLATION SUMMARY

Install an 3 or 16-bit network interface card (NIC) with a auto-boot ROM in an

option slot.

Load the remote workstation boot files onto the file server. Typically, this is

done at another attached workstation, using a floppy drive to load the

necessary boot files. Instructions for this procedure can be found in the

section of your network documentation that addresses this type of installation.

Attach the diskless workstation NIC to the network using the appropriate

cable.

When the workstation is booting, and a local hard drive with a bootable

partition is present, the system will ask if you want to boot from the network. If

"N" is selected, the local hard drive will be used to boot. If 'Y' is selected, the

system will look for a file server. If no file server can be found, it will display

an "Error finding server" message, and will make additional attempts every few

seconds until a server is found.

FLOPPY DRIVE INSTALLATION

Floppy disk drives are inserted into the drive bays, without FDD guide rails,

using four screws to secure each drive.

Two floppy drive cables are included. A read/write cable (standard seven wire

twist) and a read-only cable (identified by heat shrink tubing located near the

connector that connects to the main board).

Install the standard diskette drive cable, if you want the system to be able to

both read and write data to a diskette inserted in the drive.

PSB No: S-0134

Originator: APA

EPSON