- ページ 8

デスクトップ Epson Equity 4のPDF 仕様をオンラインで閲覧またはダウンロードできます。Epson Equity 4 9 ページ。 Product information guide
Epson Equity 4 にも：製品サポート速報 (9 ページ), 製品情報マニュアル (9 ページ)

ページを印刷する

EPSON Equity 4+

lnstallation / Support Tips

Mouse and Keyboard

computer, be careful to plug them into the proper ports.

Although the ports are physically identical, they are not

interchangeable, and damage may occur to the main

system board if you plug the connectors into the wrong

ports.

Installing Diskette Drives

in the SETUP program.

Installing Hard Disk Drives

It is recommended that a 16-bit, AT-type hard disk

controller be used if you are installing a drive that cannot

use the embedded IDE interface. If you install a non-IDE

hard disk drive and controller card, you need to use the

SETUP program to disable the built-in IDE hard disk drive

interface.

When installing a hard disk drive, see the hard disk drive

types table on page 7 and use the SETUP program to select

the correct type number for the drive. You can select a

type number that matches the parameters for the drive or

a type number with parameters having lesser values, as

long as they do not exceed the maximum capacity (in MB)

of the drive. If there is no match for the drive, you can

select a user-defined drive type (47) and enter the drive's

exact parameters.

Software Problems

try the installation at fast speed. If this does not work

properly, select slow speed by pressing the

keys and the - key on the numeric keypad

simultaneously. Try loading the program at slow speed

and then switching to fast speed, if possible.

copy-protection method, try loading it at fast speed. If this

does not work, load it at slow speed.

EPSON Equity 4+ 8

Password

Make sure that you do not forget the password you set up.

If you do:

1. Disable it by setting DIP switch 4 on the main system

2. Then turn the computer on and off again.

3. Set DIP switch 4 to ON to enable the password function.

4. Run SETUP to enter a new password, if desired.

Users can enter a hot key designation in SETUP to secure

the system from unauthorized users. Once a password

and hot key have been set, when the hot key is pressed,

the keyboard and mouse lock until the user enters the

password.

Booting Sequence

make sure the booting sequence in the SETUP program is

set to A, C. Then boot the computer from a system diskette

in drive A.

Information Reference List

Engineering Change Notices

None.

Technical Information Bulletins

None.

Product Support Bulletins

None.

and Alt

Ctrl