- ページ 28

ベビーモニター Motorola EASE34-4のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Motorola EASE34-4 38 ページ。 4.3" wi-fi video baby monitor
Motorola EASE34-4 にも：クイック・スタート・マニュアル (2 ページ)

ページを印刷する

11. Help

Display

• Try recharging the battery pack.

• Reset the Units. Unplug both the Units' electrical power, then plug them back in.

• Is the Unit switched on?

• Press and hold the ON/OFF button 0 on the Parent Unit for 3 seconds to

switch it ON.

• Is the correct camera selected? Change the camera number, if necessary.

• Is the video display turned on? Press the VIDEO ON/OFF button

V to turn it ON.

• When operating using batteries only, the display will go blank after 5 minutes or

30 minutes or 60 minutes to save power (depending on video settings). The Unit

is still active and will give you audio alerts. You can reactivate the screen by

pressing any button.

Registration

If the Baby Unit has lost its link with the Parent Unit

• If the Baby Unit is too far away it may be going out of range, so move the

Baby Unit closer to the Parent Unit.

• Reset both the Parent Unit and Baby Unit by disconnecting them from the

electrical power. Wait about 15 seconds before reconnecting. Allow up to one

minute for the Baby Unit and the Parent Unit to synchronize.

• See 2.3 Registration (Pairing), if there is a need to re-register the Units.

Interference

Noise interference on your Parent Unit

• Your Baby and Parent Units may be too close. Move them further apart.

• Make sure there is at least 1 to 2m between the 2 Units to avoid audio

feedback.

• lf the Baby Unit is too far away, it may be out of range. Move the Baby Unit

closer to the Parent Unit.

Help