- ページ 8

ベビーモニター Motorola FOCUS86のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Motorola FOCUS86 18 ページ。 Works with focus86 wi-fi home video camera
Motorola FOCUS86 にも：クイック・スタート・マニュアル (8 ページ), クイック・スタート・マニュアル (2 ページ), ユーザーマニュアル (38 ページ), クイック・スタート・マニュアル (4 ページ)

5. Add Focus TAG as a Motion Sensor

1. Make sure that you have correctly installed the battery on Focus TAG. (see

"Remove Plastic Strip to Power On" on page 6)

2. Run Hubble for Motorola Monitors App on your Android™ or iOS device.

3. Press and hold the PAIR button on Focus TAG for 5 seconds to begin

pairing it with your Android™ or iOS device. (see "Overview of Focus

TAG" on page 5 for the location of the PAIR button)

4. Select your FOCUS86 Camera.

5. Tap to select Door motion sensor.

6. Enter a name for Focus TAG, such as Front Door, Backyard Door, Bedroom

Window, and tap Continue.

7. Stick Focus TAG to the door.

Ensure that the door is closed and the distance between the door and

FOCUS86 Camera is not more than 91 metres.

8. Continue appears at the bottom of the screen and you must click

Continue to move on.

9. It will take a few minutes to check if motion sensing by Focus TAG can be

read by your FOCUS86 Camera.

A green tick appears when set up completes successfully.

10. If setup fails, tap Retry and repeat the steps starting from step 1.

11. To activate motion sensing, tap ACTIVATE NOW.

Note

The coverage area for movement detection is approximately 300 feet (91 meters)

between FOCUS86 Camera and Focus TAG.

There is a 30-second cool off period after a movement is detected.

There are 5 sensitivity options for movement detection, where "High" is the

most sensitive and "Low" is the least sensitive.

5.1

You can pair up to 5 Focus TAGs with your FOCUS86 Camera in your Hubble

Account.

To add another Focus TAG, repeat the steps in 5. "Add Focus TAG as a Motion

Sensor".

Add Focus TAG as a Motion Sensor