楽器アクセサリー DiMarzio Ultra JazzのPDF オールインワン・クイックスタートマニュアルをオンラインで閲覧またはダウンロードできます。DiMarzio Ultra Jazz 2 ページ。

D i M a r z i o . c o m

DiMarzio Model J™ and Ultra Jazz™

Important: Read all of the following instructions before proceeding. If any

questions or problems arise, you may refer them directly to us.

Your new pickup is a direct replacement for the original pickups in all

Jazz Basses. (No modification to the Jazz Bass is necessary for

installation.) The installation of an optional miniature switch will

provide the pickup with series/parallel. Phase reversal is also

possible. Further information on the options is available direct from

DiMarzio, Inc.

REMOVING THE ORIGINAL PICKUP

The front pickup will be called pickup one; the bridge pickup will be

called pickup two. Loosen or remove the strings. Unscrew all screws

fastening the pickguard to the bass and carefully remove the

pickguard. Unscrew the screws holding down the control plate and

carefully turn it over so that the controls are exposed. Unsolder the

pickup leads from the volume pots. The hot lead is connected to the

#2 leg of the pot. The ground is connected to the back of the pot. Be

careful not to disconnect the other ground wire from the back of

volume pot #2. Pickup one is connected to volume pot #1, pickup two

to volume pot #2. Unscrew the four screws holding each pickup in

place and remove the original pickups. You are now ready to install

the new pickups.

INSTALLING THE NEW PICKUPS

It will be necessary to remove the foam rubber which is attached to

the plate beneath the pickups, as the new pickups are slightly deeper

than the original. Cut a smaller piece of the packing foam, about 3" x

5/8", and place it beneath each of the pickups to give them some

cushioning. Install the pickups in their respective compartments and

run all four wires from each through to the control compartment.

Screw the pickup in with the original mounting screws.

WIRING THE PICKUPS

Solder the red wire of each pickup to leg #2 of its respective volume

pot. Solder the green wire of each pickup to the back of its respective

volume pot. Solder the black and white wire of each pickup together.

Put a piece of tape on this connection so that it does not touch any

http://www.dimarzio.com/install/ultra_jazz.html

Page 1 of 2

5/6/2004