- ページ 16

コードレス電話 Motorola D200 seriesのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Motorola D200 series 28 ページ。 D200 series digital cordless phone
Motorola D200 series にも： ユーザーマニュアル (28 ページ), 仕様書 (2 ページ)

ページを印刷する
Motorola D200 series オーナーズマニュアル

Call barring

When switched on, Call Barring prevents calls being made.
1. Press
to access the main menu.
2. Press
or
to select "HS SETTINGS". Press
3. Press
or
to select "BARRING". Press
4. "PIN ?" is displayed. Enter the PIN code using the number
keypad. Press
5. Press
or
to select "ON" or "OFF". Press

9. Settings menu

Tones

You can switch on or off the tones for key touch, battery low,
and out-of-range alarm.
For example, when the key tone is set to ON, you will hear a
tone each time you press a keypad button.
1. Press
to access the main menu.
2. Press
or
to select "HS SETTINGS". Press
3. Press
or
to select "TONE SETUP". Press
4. Press
or
to select the option you want
"KEY TONE"
"BATTERY LOW"
"RANGE ALARM"
Press
.
5. Press
or
to display either "ON" or "OFF". Press
confirm.
14
.
.
.
to confirm.
.
.

Flash

Recall is used when connected to certain switchboards, for
transferring calls to another extension number, and for some
network services. Contact your network or switchboard
provider for advice on how to use the

Changing the flash time

You can select the flash time from short or long according to
your switchboard requirements.
Consult your switchboard provider for advice if unsure which
setting you need.
1. Press
to access the main menu.
2. Press
or
until "BS SETTINGS" is displayed and press
.
3. Press
or
to select "FLASH TIME" and press
4. Press
or
to select "SHORT" or "LONG" and press

Dial mode

You can set your phone to use either Tone or Pulse dialling.
The pre-set setting is TONE dialling, where you will hear a tone
beep each time you dial a number.
Most modern exchanges and switchboards use Tone dialling,
so you should not need to change this setting. Only change it
if your switchboard uses Pulse dialling or if you cannot make a
call using Tone dialling.
1. Press
to access the main menu.
2. Press
or
until "BS SETTINGS" is displayed and press
.
to
(flash) button.
.
.