- ページ 40

コードレス電話 Motorola T604のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Motorola T604 44 ページ。 Digital cordless telephone
Motorola T604 にも：マニュアル (44 ページ)

FCC Exposure to Radio Frequency (RF) Signals

For Handset

This is a radio transmitter and receiver. It is designed and manufactured not to

exceed the emission limits for exposure to radio frequency (RF) energy set by

the Federal Communications Commission (FCC) of the U.S. Government. These

limits are part of comprehensive guidelines and establish permitted levels of

RF energy for the general population. The guidelines are based on the safety

standards previously set by both U.S. and international standards bodies.

These standards include a substantial safety margin designed to assure the

safety of all persons, regardless of age and health. This device and its antenna

must not be collocated or operating in conjunction with any other antenna

or transmitter. This product has been shown to be capable of compliance for

localized specific absorption rate (SAR) for uncontrolled environment/general

population exposure limits specified in ANSI/IEEE Std. C95.1-1992 and had

been tested in accordance with the measurement procedures specified in FCC/

OET Bulletin 65 Supplement C (2001) and IEEE 1528.

For Base

This equipment complies with FCC radiation exposure limits set forth for an

uncontrolled environment. This equipment should be installed and operated

with minimum distance 20cm between the radiator& your body.

This transmitter must not be co-located or operating in conjunction with any

other antenna or transmitter.

ISEDC Warning

This device complies with Innovation, Science, and Economic Development

Canada licence-exempt RSS standard(s). Operation is subject to

the following two conditions:

(1) this device may not cause interference, and

(2) this device must accept any interference, including

interference that may cause undesired operation of the device.

The device is compliance with RF exposure guidelines, users can

obtain Canadian information on RF exposure and compliance.

ISEDC Specific Absorption Rate (SAR) information

For Handset

SAR tests are conducted using standard operating positions accepted by the

ISEDC with device transmitting at its highest certified power level in all tested

frequency bands, although the SAR is determined at the highest certified

power level, the actual SAR level of the device while operating can be well

below the maximum value. Before a new model device is an available for sale

to the public, it must be tested and certified to the ISEDC that it does not

exceed the exposure limit established by the ISEDC, tests for each device

are performed in positions and locations as required by the ISEDC. For body

worn operation, this model device has been tested and meets the ISEDC RF

exposure guidelines when used with an accessory designated for this product

or when used with an accessory that contains no metal.

General information