- ページ 6
ラジオ Motorola GM350のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Motorola GM350 8 ページ。 Remote mount kit
Motorola GM350 にも： ユーザーマニュアル (7 ページ), インストレーション・マニュアル (10 ページ)
ページを印刷する
GM350 Mobile Radio Connection Information
2.0
GM350 Mobile Radio Connection Information
To run the Radio Service Software (RSS), you will need the following equipment:
1.
IBM 386 DX 33 or equivalent with 8 MByte RAM, Hard Disk with 10MBytes free disk space and
3.5" Floppy Disk Drive.
2.
WIN 3.1
3.
Radio Interface Box (RIB) RLN4008B.
4.
RIB to Computer, cable 3080369B71 / 72.
5.
RIB power supply EPN4040A / EPN4041A (220 VAC) or 9V battery.
6.
Radio to RIB, Programming/Test cable GTF374A .
7.
Radio Power Supply GPN6133A or equivalent.
RIB Power Supply
EPN4040A PSU U.K. plug
EPN4041A EURO plug
2.1
Configuring the RIB and GM350 Radio
1.
Connect the RIB to the computer (Figure 1-1) using the interface cable 3080369B71 or 3080369B72
depending on the computer connection to Serial COM Port 1. If you are unsure of the connection on the
back of your computer or the COM port, then please consult the computer manuals.
2.
Plug the 25 pin end of the Radio programming cable, GTF374A into the RIB. Then plug the other end
into the MIC connector on the radio.
3.
Connect the RIB Power supply to the RIB and plug the other end into a wall outlet, (alternatively a 9V
battery may be used instead of the power supply).
4.
Connect the radio to a power source and press the On/Off button to turn the radio on.
1-2
TM
TM
, MSDOS
5.0 or later.
RIB to Computer Cable.
Plugs into RIB and computer.
3080369B71 Interface cable IBM XT 25pin
3080369B72 Interface cable IBM AT 9pin
15 PIN
25 PIN
GPN6133A
Power Supply
or equivalent
Figure 1-1
GM350 Radio Programming Setup.
RLN4008B
Radio
Interface
Box
GTF374A
Std programming cable.
Plugs between the RIB and
radio MIC connector.
User Manual
Computer
Software
GM350
Mobile Radio
GKN6266A
DC cable for base
operation or equivalent.
RSS Installation Manual