- ページ 37
ラジオ Motorola GP240のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Motorola GP240 46 ページ。 Professional radio, power distribution and controller
Motorola GP240 にも: ユーザーマニュアル (46 ページ), サービス情報 (32 ページ), サービス情報 (30 ページ), サービス情報 (30 ページ)
UG_240_280_EN.fm Page 33 Wednesday, August 14, 2002 10:30 AM
Note: The call received status annunciator, F,
flashes when you receive a call, but is not
displayed when you answer the call.
Making a Telephone Call
(GP280 radios only)
There are three phases in making a phone call,
namely
• accessing the telephone system,
• sending the telephone number,
• having the conversation and hanging-up.
Accessing the Telephone System
1. Press / until PHON
is displayed.
2. Press l (the softkey below PHON).
3. Your radio attempts to access the telephone
system.
4. If you connect successfully, you will hear a dial
tone.
5. The display will show the
last number dialed.
Downloaded from
www.Manualslib.com
MSG
SCAN PHON
5551135
manuals search engine
Sending the Telephone Number
Sending the telephone number using the keypad
6a. The number can now be entered from the
keypad, using any of the numeric (0 – 9) keys,
and the "*" and "#" keys. The cursor flashes to
indicate the location of the next digit to be
entered. A pause can be entered in the
telephone number by first pressing the "*" key,
then the "#" key (Buffered dial only - The
pause will be shown on the display as a "P").
6b. If your radio is programmed for "live dial,"
each digit is sent out as its key is pressed.
If your radio is programmed for "buffered dial,"
each digit is temporarily stored as you enter
them. After entering the number, press the
PTT switch to send out the number.
6c. The telephone number will be sent out; you
will hear tones as they are sent. If you hear a
busy signal, go to step 8 for hang-up
procedure.
—or—