- ページ 8

ラジオ Motorola GP340 ATEXのPDF サービス情報をオンラインで閲覧またはダウンロードできます。Motorola GP340 ATEX 30 ページ。 Professional radio, power distribution and controller
Motorola GP340 ATEX にも：仕様書 (5 ページ), ユーザーマニュアル (31 ページ), 仕様書 (2 ページ), ユーザーマニュアル (30 ページ), ユーザーマニュアル (30 ページ), 基本マニュアル (10 ページ), サービス情報 (32 ページ), サービス情報 (30 ページ), サービス情報 (26 ページ), サービス情報 (24 ページ), サービス情報 (31 ページ), サービス情報 (43 ページ)

1-4

A MOSFET Q416 switches in the LiO supply when Vdd is removed. Q416 also provides isolation

from BOOT_CTRL function in the event of radio program flashing. The 3.3V regulator charges the

Lithium battery.

3.4

ModB/Vstby Supply

The supply to the ModB/Vstby pin varies depending on the conditions listed in Table 1-2.

Radio On

Radio Off

Primary battery removed

Flash Mode

3.5

Audio/Signalling Architecture

( Refer to Figure 1-2 and the ASFIC/ON_OFF and Audio Power Amplifier schematic diagrams )

The audio/signalling/filter/companding IC (ASFIC_CMP) and the audio power amplifier, shown in

Figure 1-2, form the main components of the audio/signalling architecture section of the controller

board. Inputs include a 16.8 MHz clock from the synthesizer, recovered audio and squelch, MCU

control signals, and external or internal microphones. Outputs include a microprocessor clock (uP),

modulator output to the synthesizer, and amplified audio signals to an internal or external speaker.

Table 1-2 ModB/Vstby Supply Modes

Condition

Circuit Operation

Vdd supply voltage via CR411

• Vdd turned off

• Q416 gate pulled low by R462

• Q416 switched on

• U410 supplies 3.2V to ModB/Vstby

• Vdd turned off

• Q416 gate pulled low by R462

• Q416 switched on

• Lithium battery provides 3.2V to ModB/Vstby

• Boot_Ctrl line pulled low

• ModA & ModB go low

• Processor in boot-strap mode

THEORY OF OPERATION