- ページ 11

ラジオ Motorola MSAT-G2のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Motorola MSAT-G2 31 ページ。 Mobile satellite radio

Standard Cable Connections

In addition to the DC power connection, optional horn alert and ignition sense connections

may be made. These are all done using the four wire power cable. In the case of a vehicle

installation, the power source is typically the vehicle battery. Cables should be routed

appropriately and cable ties and clamps should be used as required to ensure that vibration

and/or rubbing of the cables does not occur.

To install the Horn Alert, route and splice the blue wire (Horn Alert) as shown below.

Note that the Horn Alert option is not available in Dispatch Radio mode.

12 VDC or ground as

required by vehicle

To auto horn

+12 VDC

Note: 0.25

amp fuse

required

To TU Horn Alert

(GND) (BLUE Wire)

Figure 12 – Horn Alert Wiring Diagram

Route and connect the orange wire (Ignition Sense) to a switched 12 VDC source, such

as ignition switch or fuse block. Extended use of ignition sense in accessory position

(ACC) by the end user may lead to a discharged car battery.

NOTE: Ensure that the connection is a switched source-OFF when ignition is off or in

start and ON only when ignition switch is in ACCESSORIES or RUN position.

MSAT-G2 Installation Guide