- ページ 9
ラジオ Motorola Professional GP640のPDF サービス情報をオンラインで閲覧またはダウンロードできます。Motorola Professional GP640 26 ページ。 Professional radio, power distribution and controller
Motorola Professional GP640 にも： ユーザーマニュアル (32 ページ), 仕様書 (2 ページ), サービス情報 (28 ページ), サービス情報 (32 ページ), サービス情報 (30 ページ), サービス情報 (43 ページ), サービス情報 (30 ページ)
ページを印刷する
1.0
Introduction
This Chapter provides a detailed theory of operation for the 300-350MHz circuits in the radio. For
details of the theory of operation and trouble shooting for the the associated Controller circuits refer
to the Controller Section of this manual.
2.0
Transmitter
(Refer to Figure 2-1 and the Transmitter schematic diagram)
The transmitter contains five basic circuits:
1.
power amplifier,
2.
antenna switch,
3.
harmonic filter,
4.
antenna matching network,
5.
power control integrated circuit (PCIC).
From
VCO
2.1
Power Amplifier
The power amplifier consists of two devices:
1.
9Z67 LDMOS driver IC (U101) and
2.
PRF1507 LDMOS PA (Q110).
The 9Z67 LDMOS driver IC contains 2 stages of amplification with a supply voltage of 7.3V.
This RF power amplifier is capable of supplying an output power of 0.3W (pin 6 and 7) with an input
signal of 2mW (3dBm) (pin16). The current drain would typically be 160mA while operating in the
frequency range of 300-350MHz.
P CI C
Vcontrol
Power
Amplifier
PA
Driver
Figure 2-1 Transmitter Block Diagram.
THEORY OF OPERATION
Vcontrol
P A Final
Antenna Switch/
S t a g e
Harmonic Filter
Chapter 2
Antenna
Matching
Network