- ページ 18

ポータブルラジオ Motorola Astro APX 6000Li SeriesのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Motorola Astro APX 6000Li Series 45 ページ。 Digital portable radios
Motorola Astro APX 6000Li Series にも：クイック・リファレンス・マニュアル (48 ページ), クイック・リファレンス・マニュアル (48 ページ), クイック・リファレンス・カード (2 ページ), クイック・リファレンス・カード (2 ページ), クイック・リファレンス・カード (2 ページ)

3. When the bracket is mounted in carpet, the self-tapping screws tend

to bind up. To overcome this, tap the screw through the carpet, back

out the screw, then tighten the screw down.

1. Use the console to trunnion screws from the kit packaging (unit box).

2. Ensure that the plastic guides of the trunnion are aligned (horizontally)

with the corresponding grooves of the console (see Figure 2). Slide the

APX VA console into the plastic guides until it reaches the mechanical

stop. Verify that the holes in the trunnion bracket are aligned with the

holes on the APX VA.

3. Insert the Allen-screws provided through the trunnion bracket and screw

them into the console. Since the console may have to be removed later to

connect the cables, do not tighten the screws at this time.

Microphone Bracket Installation

Note: The microphone bracket should be mounted on a substantial structure.

Otherwise, repeated insertion and removal of the microphone could

loosen it. Referring to Figure 3, use the microphone bracket as a

template and drill two 1/8-inch (0.32cm) holes. Attach the microphone

bracket to the mounting surface with the two self-tapping screws

provided. Be sure to leave sufficient room above the bracket for

inserting and removing the microphone.

Figure 1: Console Installation Detail

M5 x 18mm Mounting

Bracket Hardware

Note: Use only the M5 x 18mm

screws supplied with the unit.