- ページ 7

ポータブルラジオ Motorola RADIUS GP300のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Motorola RADIUS GP300 47 ページ。 Portable radios
Motorola RADIUS GP300 にも：マニュアル (15 ページ)

ページを印刷する

To Transmit

1. Turn the radio on and rotate the CHANNEL

SELECTOR to the desired channel position.

2. Press the MONITOR BUTTON to listen for

activity on your channel.

3. While holding the radio two to three inches

from your mouth, press the PTT button on the

side of the radio and speak. The LED glows

red to indicate transmit status. When ﬁnished

transmitting, release the PTT button to

receive.

NOTE

When the PTT button is depressed,

the LED ﬂashes red if there is a low

battery condition. In addition, a double

alert tone is sounded when the PTT

button is released.

Time-Out-Timer (T.O.T)

The T.O.T feature ends a transmission which is

over 60 seconds in length. After time out, a con-

tinuous alert tone sounds until the PTT button is

released.

Voice Activated Transmission

(VOX)

To activate the VOX feature, insert a headset in

the accessory connector on a channel pro-

grammed for VOX. You can gain manual control

of the radio by pressing the PTT button at any

time. In order to restart the VOX feature, the

radio must be turned off/on or the channel must

be changed.

Optional Feature Enhancements

(Not Available on 2 Channel

Models)

Channel Scan

To initiate the scan feature, rotate the CHAN-

NEL SELECTOR to the location with the scan

list programmed to it. The radio will stop on any

active channel and you will be able to hear the

conversation. The radio scans for PL/DPL

unless the monitor feature is active and CSQ

scan will operate. To locate the last active scan

channel, rotate the CHANNEL SELECTOR and

the radio beeps when that channel is reached.

To temporarily eliminate a channel from the

scan list, press the side NUISANCE DELETE

BUTTON while the nuisance channel is active.

PTT ID (Encode)

Every time the PTT button is pressed, the radio

automatically transmits a unit identiﬁcation (ID)

number. While holding the PTT button, a tone

may be heard while the unit ID number is being

sent out.

Call Alert (Decode)

When a Call Alert is received, the monitor LED

ﬂashes yellow and a series of 4 alert tones

sound. A Call Alert "leaves a message" for the

mobile operator. The monitor LED continues to

ﬂash yellow, and the alert tones repeat every 10

seconds until the PTT or any other button is

pressed. The radio then returns to normal oper-

ation.

Voice Selective Call (Decode)

When a Voice Selective Call is received, a one-

time 2 beep alert tone sounds, the monitor LED

ﬂashes yellow and the radio emits a voice mes-

sage. After the transmission is completed, the

radio returns to normal operation.