- ページ 30
ヘッドセット Motorola clp446のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Motorola clp446 46 ページ。 Clp series two-way radio
Motorola clp446 にも： ユーザー・インストラクション (9 ページ), クイック・リファレンス (35 ページ)
ページを印刷する
2.
Plug one side of the cloning cable
microconnector to one Single Unit Charger.
Plug the other end to the second Single Unit
Charger.
Note:
During the cloning process no power is
being applied to the Single Unit Charger.
The batteries cannot be charged. A data
communication is being established
between the two radios.
3.
Turn ON the "Target Radio" and place it into
one of the Single Unit Chargers.
4.
On the "Source Radio", power the radio
following the sequence below: • Press and
hold the Push-to-Talk (PTT) and the "-"
Button simultaneously while turning the radio
ON until you hear the Cloning Tone and
Double Blinking Yellow
Status Glow.
5.
Place the "Source Radio" in its Single Unit
Charger with an Audio accessory, then press
and release Menu Button to start the cloning
process.
22
English
6.
7.
on the Smart
After cloning is completed, the "Source
Radio" sounds either a "pass" tone (cloning
was successful) or a "fail" tone (cloning
process has failed). The pass tone sounds
like a good key "chirp" whereas the "fail" tone
sounds similar to a "bonk" tone. (A tone is
heard in no more than 5 seconds).
Once you have completed the cloning
process, you should turn the radios "OFF"
and "ON" to bring them to normal user mode
(exit "clone" mode).