- ページ 2
ヘッドセット Motorola H560 - Headset - Over-the-earのPDF クイックスタートをオンラインで閲覧またはダウンロードできます。Motorola H560 - Headset - Over-the-ear 2 ページ。 Bluetooth handsfree headset
Motorola H560 - Headset - Over-the-ear にも： ユーザーマニュアル (15 ページ), クイック・スタート・マニュアル (6 ページ)
ページを印刷する
To turn your headset on, open the
headset boom. The indicator light flashes
blue if paired with another device, or is
H700
steadily lit in purple if ready to be paired.
Bluetooth®
To turn your headset off, close the
Handsfree Headset
headset boom. The indicator light will turn
off.
To conserve battery power, turn off your
headset when you don't plan to use it for
IMPORTANT:
IMPORTANT:
Be sure to first follow the
Be sure to first follow the
Quick Start Guide
Quick Start Guide
on the reverse side to
on the reverse side to
complete initial setup of
complete initial setup of
Multi-Color
your H700.
your H700.
Indicator Light
Function
Make a voice dial call
End a call
Receive a call
Reject a call
Redial last call
Note: Your H700 supports both Handsfree and Headset
Profiles. Accessing call functions depends upon which
profile your phone supports. See your phone's user's guide
for more information.
TURNING ON AND OFF
1
2
3
4
MAKING CALLS
Action
Function
Tap the Call button
Answer a second
incoming call
and speak the
name after the tone
Tap the Call button
Toggle between two
active calls
Open headset boom
Join a 3-way call
or tap the Call button
(if boom is already
Put an active call on
open)
hold or resume a call
Press and hold the
on hold
Call button until you
Transfer a call from the
hear a beep
phone to the headset
Press and hold the
Disable the
Call button until you
indicator light
hear a beep
Mute or unmute a call
Note: Some features are phone/network dependent.
WEARING THE
HEADSET
You can wear your H700 headset on your left or
Open the headset boom, then open the
right ear. The headset comes ready for the right
earhook (45 from the headset).
ear. To change the headset for the left ear:
Loop the earhook over your ear.
1
Press the headset to your ear.
Point the headset boom towards your
2
mouth.
3
4
MAKING CALLS
CONTINUED
Action
Press and hold the
Call button (places
first call on hold)
Press and hold
the Call button
Press and hold
both Volume buttons
Press and hold the
Call button until you
hear a beep
Open headset boom
Press and hold
both Volume
buttons for 3 to 4
seconds
Tap both Volume
buttons
CHANGING FOR USE
ON OTHER EAR
Open the headset boom,
then open the earhook
(90 from the headset).
Gently lift and pull the
top of the earhook up
1 Open Earhook
and off the upper hinge
pin. Then, pull it away to
remove it.
2 Pull Earhook Up
Flip the headset over.
Hook the bottom of the
earhook onto the lower
hinge pin, then lift and
Hinge Pin
pull the top of the
earhook over the upper
hinge pin.
INDICATOR LIGHTS
With the Charger Plugged In
Indicator Light
Headset Status
Red (steady)
Charging (less than
80% charged)
Yellow (steady)
Charging (more than
80% charged)
Green (steady)
Charging complete
With No Charger Plugged In
Indicator Light
Headset Status
Off
Power off
Purple (steady)
Pairing mode/
Volume button
orientation
Red
Battery low
Blue (10 rapid flashes) Pairing successful
Blue (slow pulse)
Connected (on a call)
Blue (quick flash)
Standby (not on call)
Note: After 5 minutes of inactivity, the light stops flashing to
conserve power, but the headset remains in standby mode.
CHANGING VOLUME
BUTTON ORIENTATION
You can also change the orientation of the
volume buttons on your headset.
1
Turn the headset power off by closing
the headset boom.
2
Press the Call
button until the
E
indicator light becomes steadily lit in
purple, then press the Volume button
you want to assign as the "volume up"
button.
Call
Button
Volume
Buttons
AUDIO TONES
The audio tones provide information about your
headset status.
Audio Ton e
Headset Status
Single high tone when
Volume at minimum
pressing Volume button
or maximum
Five rapid high tones
Low battery
repeated every 60 sec.
No audio indications;
Out of range
deteriorating quality
Ring tone
Incoming call
Single high tone
Pairing confirmation
Single low tone
Voice activation
Dual high/low tone
Voice tag not
recognized
Single high tone
End call
Low to high tone
Phone network
not available
Two ascending tones
Mute enabled
Two descending tones
Mute disabled