- ページ 2
ヘッドセット Motorola H710 - Headset - Over-the-earのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Motorola H710 - Headset - Over-the-ear 2 ページ。 Bluetooth handsfree headset
Motorola H710 - Headset - Over-the-ear にも: クイック・スタート・マニュアル (6 ページ), クイック・スタート・マニュアル (1 ページ)
Features and
TURNING HEADSET
ON AND OFF
Functions Guide
To turn your headset on, open the headset
boom. The indicator light flashes blue (if
connected with a device) or is steadilly lit (if
ready to be paired).
To turn your headset off, close the
headset boom. The indicator light will turn
off.
IMPORTANT:
Multi-Color
Be sure to first follow the
Indicator Light
Quick Start Guide
on the reverse side
of this guide
to complete initial setup
of your H710.
MAKING CALLS
European Union Directives
Function
Conformance Statement
Make a voice dial call
Hereby, Motorola declares that this
(Primary phone)
product is in compliance with:
• The essential requirements and
Make a voice dial call
other relevant provisions of Directive
(Secondary phone)
1999/5/EC.
• All other relevant EU Directives.
End a call
Answer a call
Product
Approval
Number
The above gives an example of a typical Product
Approval Number.
Ignore a call
You can view your product's Declaration of Conformity
(DoC) to Directive 1999/5/EC (to R&TTE Directive) at
www.motorola.com/rtte. To find your DoC, enter the
product Approval Number from your product's label in
Note: Your H710 supports both Handsfree and Headset
the "Search" bar on the web site.
Profiles. Accessing call functions depends upon which
profile your phone supports. See your phone's user's guide
for more information.
WEARING THE HEADSET
1
Open the headset boom, then open the
earhook.
2
Loop the earhook over your ear.
3
Press the headset to your ear.
4
Point the headset boom towards your
mouth.
MAKING CALLS
CONTINUED
Action
Function
Action
Tap the Call button
Redial last call
Press and hold the
and speak the
Call button until you
name after the tone
hear a beep
Tap the Call button
Answer a second
Press and hold the
and either Voume
incoming call
Call button (places
button and speak the
first call on hold)
name after the tone
Reject second incoming
Press and hold either
Tap the Call button
call
Volume button until
you hear a beep
Open headset boom
or tap the Call button
Transfer a call from the
Press both Volume
(if boom is already
headset to the phone
buttons and Call
open)
button
Disable the
Press and hold
Press and hold the
indicator light
both Volume
Call button until you
buttons while
hear a beep
powering on headset
Mute or unmute a call
Tap both Volume
buttons
Note: Some features are phone/network dependent.
CHANGING VOLUME
CHANGING FOR USE
ON OTHER EAR
BUTTON ORIENTATION
You can also change the orientation of the
You can wear your H710 headset on your left or
volume buttons on your headset.
right ear. The headset comes ready for the right
ear. To change the headset for the left ear:
1
Turn the headset power off.
1
Open the headset boom,
then open the earhook
2
Press and hold down the desired
(90° from the headset).
"volume up" button and open the boom.
Keep the button held down until the
2
Gently lift and pull the
indicator light flashes blue three times.
top of the earhook up
and off the upper hinge
1 Open Earhook
pin. Then, pull it away to
remove it.
2 Pull Earhook
Up
3
Volume
Flip the headset over.
Buttons
4
Hook the bottom of the
earhook onto the lower
hinge pin, then lift and
pull the top of the
Hinge
earhook over the upper
Pin
hinge pin.
INDICATOR LIGHT
INDICATOR LIGHT
With the Charger Plugged In
With No Charger Plugged In
Headset Indicator
Headset Status
Headset Indicator
Red
Charging (battery
Off
level less than 80%
Three blue flashes
charge)
Steady blue
Yellow
Charging (battery
Rapid blue/purple flashes Pairing successful
level more than 80%
charge)
Quick blue flash
Green
Charging complete
Slow blue pulse
Slow blue flash
When Checking Battery Level
Slow red flash
Headset Indicator
Headset Status
Red
Battery at less than
Slow purple pulse
10% charge
Quick red flash
Yellow
Battery between
Note: After 20 minutes on a call or of inactivity, the light stops
10% and 80% charge
flashing to conserve power, but the headset remains on.
Green
Battery at more than
80% charge
CHECKING
BATTERY LEVEL
While turned on and not on a call, you can
check your headset's battery charge level
by pressing and holding both Volume
buttons.
The indicator light displays charge status
until you release the buttons. See "Indicator
Light" for details on indicator light and
charge status.
Call
Button
AUDIO TONES
Headset Status
Power off
Powering on/off
Pairing mode
Incoming/outgoing call
Connected (on a call)
Standby (not on a call)
Idle (not connected
to phone)
Connected call muted
Low battery