Installing the Printer Horizontally or Vertically
You can install the printer horizontally on a flat surface (with the paper exit on top) or
vertically (with the paper exit at the front) by hanging it on a wall, using the optional WH-
10 hanging bracket set.
WARNING:
When hanging the printer on the wall with the hanging bracket set, be sure to attach a connector
cover to the printer.
Control Panel
FEED button
This button feeds paper.
(Power) LED
This LED is on when the printer is on.
ERROR LED
This indicates an error.
PAPER OUT LED
On indicates a paper near end or out. Flashing indicates standby.
Using the Power Switch Cover
WARNING:
If an accident occurs with the power switch cover attached, unplug the power cord immediately.
Continued use may cause fire or shock.
The enclosed power switch cover ensures that the power switch is not pressed accidentally.
To use this cover, install it as shown in illustration B.
Attaching and Removing the Connector Cover
These instructions apply if a connector cover is packed with your printer to protect your
cables. To attach it, follow the steps below:
1.
First, connect all the cables. The connector cover has three possible cable exits: on the
right, left, and back.
2.
Position the two hooks on the connector cover so that they hook the printer case, as
shown in illustration C.
3.
Push the connector cover down to click onto the printer case.
To remove the connector cover, turn the printer over, and push the connector cover down
while pushing both sides of the connector cover inward to detach the hooks from the
printer case. See illustration D.
Installing Roll Paper
1.
Press the button to open the cover. See illustration E.
2.
Remove the used roll paper core, and insert the roll paper. See illustration F.
3.
The correct direction of the paper is shown in illustration G.
4.
Pull out some paper, as shown in illustration H. Close the cover, and tear off the
paper, as shown in illustration I.
4 TM-T88IV User's Manual
ページを印刷する