Cleaning the Air Filter and Vent

Your projector includes an air ter to ensure the best performance. If

dust collects on th

Dust clogs prevent proper ventilation and can cause overheating and

damage the projector.

If you see the following message, clean the air ter immediately.

The projector is overheating. Make sure nothing is blocking the

air vent, and clean or replace the air filter.

1. Turn

the projector. Wait for the P power light to stop

then unplug the power cord.

2. To clean the intake vent and

designed for computers and other

have one, gently clean the vent with a soft brush (such as an

artist's paintbrush).

You can remove the air lter to clean both sides. For instructions,

see page 110.

The exhaust

vent is on the

other side of

the projector

3. If the dirt is di

ult to remove or the

message appears again after cleaning, replace the lter as described

on page 110. Contact your dealer or call Epson at

800-GO-EPSON (800-463-7766) to purchase

or vent, clean them as described below.

use a small vacuum cleaner

e equipment. If you don't

is damaged, or if the

INSTALLATION HANDBOOK

note

To order replacement air

lters, request part number

V13H134A22. See page 13

for ordering information.

Maintenance