- ページ 32
ソフトウェア Epson Perfection 1670 PhotoのPDF サービスマニュアルをオンラインで閲覧またはダウンロードできます。Epson Perfection 1670 Photo 46 ページ。 Color image scanner
Epson Perfection 1670 Photo にも: 製品情報 (7 ページ), スタートマニュアル (9 ページ), マニュアル (11 ページ), 更新 (1 ページ), 製品サポート速報 (17 ページ), 製品サポート速報 (12 ページ), 重要な安全上のご注意 (4 ページ), パンフレット&スペック (2 ページ)
![Epson Perfection 1670 Photo サービスマニュアル](/uploads/products/server2/620645/620645.jpg)
EPSON Perfection 1670 Photo/Perfection 1270
4.1 Overview
This chapter explains the maintenance work necessary to keep this product in the best
condition and to prevent problems.
4.1.1 Cleaning
If the product is noticeably dirty, clean it being careful of the following points.
Especially when the Document Glass surface is dirty, fully clean it to remove all dirt
since the read image quality is directly affected.
C A U T I O N
Never use organic solvents, such as thinner and benzene, because they
may deteriorate or degrade the plastic and rubber parts.
Exterior
After wetting a clean cloth with water and then completely squeezing water out of
it, wipe the exterior with that close. If the exterior is extremely dirty, wipe it with a
cloth moistened with a small amount of detergent.
Document Glass
Clean it with a clean, dry cloth. When the Document Glass is especially dirty or
has foreign matter on its surface, wipe it with a cloth moistened with a small
amount of pure water. If the Document Glass has traces of wiping after cleaning,
completely wipe it with a dry, clean cloth again.
Scanner inside
When the Upper Housing has been removed, much dirt and dust enter from the
outside. Therefore, reinstall the Upper Housing after fully air-blowing the scanner
inside and Upper Housing.
MAINTENANCE
4.1.2 Lubrication
Lubrication is required when any part of the Carriage Unit of the scanner has been
replaced or the Carriage moves with noticeably large operation noise. The specified
grease is indicated in Table 4-1, and the lubrication points are shown in Figure 4-1.
Type
Grease
Carriage Shaft
Figure 4-1. Lubrication Points
Note that a failure to strictly observe the specified amount of
C A U T I O N
application will contaminate the mechanisms or lead to a malfunction.
Overview
Table 4-1. Specified Grease
Name
Part Number
Supplier
G-26
1080614
Revision B
EPSON
<Lubrication
point>
Carriage
Shaft
<Oil type>
G-26
<Amount of
application>
1.0x3mm
32